Ask Experts Questions for FREE Help !
Ask
    thaggerty's Avatar
    thaggerty Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 30, 2014, 04:52 PM
    Heater shuts off without lighting or lighting for a brief moment
    The aire flo heater starts normally, when the igniter lights it stays lit for a few seconds and then the furnace shuts down. I have observed this several times. Once, the gas did ignite but only weakly and briefly (1 second) then it shut down. I'm not sure what part needs replacing. The furnace has worked well for 3 years.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Mar 30, 2014, 05:30 PM
    Make sure the flame sensor is clean, all burner tubes are clean and the gas ports are open. Start there. Without any idea of your heater it is hard to go further.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Need light fixture for a obsoleted Progress Lighting 3 circuit track lighting system [ 1 Answers ]

I have an operating Progress Lighting 3 circuit tracking system that has one broken light fixture of its seven fixtures that are still operating.I need a replacement fixture since one is broken. Where can I try to get one? Thanks, Tom Madison

Pilot is lighting on home heater but no hot air and pilot is lighting but it continue [ 0 Answers ]

Here is my problem The hot air is not coming out from a/c ven Heat was working two days ago Pilot works but it starts then goes out or low then starts again but gas to burner doesn't start main burners for heater Tried circuit breaker and on/off switch and pilot screw adjust which did not...

Lighting a wall gas heater [ 2 Answers ]

How do I light a gas wall heater

Gas heater not lighting up [ 3 Answers ]

I have a comfortmaker RPJ II and the blower will turn on when I turn the thermostat on, but the gas is not igniting. Could it be the electronic ignitor or something else that I need to check?

View more questions Search