Ask Experts Questions for FREE Help !
Ask
    gy49's Avatar
    gy49 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 6, 2013, 12:28 PM
    PC1832 alarm goes off but my cell phone not ring
    When my dsc PC 1832 alarm goes off, my cell phone does not ring immediately until I let the bell sounding goes off more than 1.5 min. Don't know how to set it calls my cell phone immediately if any event making the alarm goes off.
    All zone test trig will making the alarm go off except waiting to long for it to call my cell phone. Here is my zone setting
    001 section #
    01 Delay1 for Zone1  Front door, Garage door entry
    00 Interior for Zone2  05 Motion detector not found, thus, no used here
    03 Instant for Zone3  Living, Dining, Family room
    03 Instant for Zone4  Bed rooms, bath
    03 Instant for Zone5  Upstair windows
    03 Instant for Zone6  Side garage door
    00 Zone7 not used
    00 Zone8 not used
    #
    350 section #
    06 Assign first phone is residential
    06 Assign second phone is residential
    #
    301 section #
    DXXXXXXXEE # first phone#
    302
    DXXXXXXXEE # Second phone#
    303
    DXXXXXXXE # Backup phone# using 1st phone format
    Press 002 to go to the zone definition block that begins with zone 17
    Press 05 to program zone 17 as Interior Stay/Away
    Press 00 Skip zone 18
    Press 05 to program zone 19 as Interior Stay/Away
    Press 00 Skip zone 20
    Press 05 to program zone 21 as Interior Stay/Away
    Press # to exit the location but remain in programming mode
    Press 117, pause, then 8 to enable zone 17 as wireless
    Press # to exit the location but remain in programming mode
    Press 119, pause, then 8 to enable zone 19 as wireless
    Press # to exit the location but remain in programming mode
    Press 121, pause, then 8 to enable zone 21 as wireless
    Press # to exit the location but remain in programming mode
    Press 204, pause, then 1-,3- 5 to enable zone 17,19, 21 on partition 1
    Press # to exit the location but remain in programming mode
    Press 804 to enter the serial number program section
    For zone17,19 and 21
    320 report code for dialing out that
    01 03 04 05 06 17 19 21
    Section 310 - Account Code set to 1111
    380 opt 1 is ON

Check out some similar questions!

Programming DSC PC1832 alarm [ 3 Answers ]

HI... How do I change the delay time on a DSC PC1832 STAY-ARM key to 30 seconds delay. Thanks

Cell phone ring amplifier [ 18 Answers ]

Can anyone tell me if there is a device that you can plug your cellphone into so that It rings more like a regular land line phone, so that you can hear it in other rooms, or At night. Thanks so much

How to reset dsc alarm pc1832 [ 10 Answers ]

A friend had a problem with there alarm,there is no paper work for this panal and no codes at all,the panel is in a lockable box with no keys. I have forced the box and the panel inside is a pc1832/1864 I believe to reset the panel you have to short out pgrm1 and z1,I have done this but this has...

Keybus Fault on DSC PC1832 alarm system [ 1 Answers ]

Getting a keybus fault error on DSC PC1832 system. Board problem?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.