Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman furnace troubleshooting
[ 0 Answers ]
Inducer motor runs after shut down in heating or cooling. Status light blinks 5 times, signaling, "false flame sense" I'm perplexed.
Goodman furnace troubleshooting?
[ 0 Answers ]
I have a goodman mid efficiency furnace that was installed in my house in 2007. I have to clean the heat sensor in it about 2 to 3 times a year. I was told by a technician that this is normal for these furnaces. But even after I clean the sensor, the furnace still seems to run all the time (a...
Goodman furnace troubleshooting
[ 7 Answers ]
My goodman furnace/ heat pump will not turn on when I turn on at AC the unit outside will turn on but the blower will not. There trouble shooting light is not on.
Goodman furnace troubleshooting
[ 3 Answers ]
Goodman 95% 2 stage furnace. LED code says pressure switch is stuck open. 1) Changed switch. 2) Jumped Limit switch. 3) Changed PCB. Same error code. 3 blinks "code says pressure switch is stuck open" Can You Guide me further
Goodman furnace troubleshooting
[ 2 Answers ]
I went away for a couple of days and returned to a cold house. I have a Goodman Model HCC075ND4R that has Electronic Ignition with Relay + VR80204 - S8600H Control. I can not get it to fully ignite. It tries to ignite over and over again. I see a single blue flame for a short time, but not main... View more questions Search
|