Check out some similar questions!
Empire wall heater will not stay on
[ 0 Answers ]
I have a empire wall heater model # gwt-35-2 . 35,000 BTU. I have replaced the thermopile with a robertshaw # 1950-001 thermopile 36" 250-750 millivolts, 2 lead type. Have also replaced thermostat with Honeywell # CT33A compatible with millivolt heat only systems.Two years ago I replaced the over...
My wall heater do not start is Empire GWT 25-2
[ 0 Answers ]
The pilot is on but when I turn on the thermostate, the burner do not star.I all ready change the termo pilot and check the thermostate look fine.I put btogeter the tow line in the thermostate but steel of.
Empire wall furnace burner ignition problem.
[ 0 Answers ]
Hello; I have a LP Empire Wall Furnace model # FAW-55 SPP in my garage (hooked to a 20lb tank-full). I turn on the gas & ignite the pilot light. After a few seconds the pilot will stay on by itself as it is suppose to. I then turn the control on the furnace to "On" & the thermostat is set to at...
Problem with empire wall furnace
[ 1 Answers ]
I have a 1985 vintage Empire gravity direct vent wall furnace in out cottage mode # DV-235-3SG. Once the unit runs for a while and the room comes up to temp. the burner shuts off, but the blower keeps trying to cycle on and off - it makes an electrical sparking sound which causes interfence with...
Lighting Empire wall furnace pilot light
[ 1 Answers ]
:o, Please help! I have accessed the inside of my Empire wall furnace & understand the instructions on the knob relating to startingg the pilot light. Have lit pilots of water heaters many times. My question simply is: Where is the place to place the match to get ignition? It refers... View more questions Search
Add your answer here.
|