Ask Experts Questions for FREE Help !
Ask
    jsph_prz's Avatar
    jsph_prz Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 23, 2012, 07:47 PM
    1/2hp replaced by 2/3hp on ref. need advice
    Ice forming on suction side of compressor, what should I do?
    thermalmedics's Avatar
    thermalmedics Posts: 153, Reputation: 13
    Junior Member
    		  
    #2

    Jun 23, 2012, 08:17 PM
    Which motor did you swap out?

    Either way don't run it in case you start to suck liquid referig back to the compressor
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

208v/220v 3HP 1PH,how do I wire from panel [ 4 Answers ]

I bought a 3hp air compressor that requires 230vac my garage is 120? [ 5 Answers ]

Is there a way I can get power to the230 vac air compressor,from the 120 volt running in my garage.like piggy backing a power line to both hot connections on the outlet. Thanks... (If not,know anybody that wants to buy a new 230 vac air compressor) ...

Brigs and stratton 3hp. Plastic carb. How do I remove spring and ball bearing, [ 4 Answers ]

Has the plastic carb. How do I remove the fuel inlet. The plastic cap, spring and ball bearing? Surges, cleaned and blew out carb.

Craftsman 3HP/20 gal. Air compressor [ 1 Answers ]

My hubby just bought a used air compressor, it starts runs but shuts down quickly, it seems to be air locked , is there a way to fix this?

B/s 3hp engine [ 2 Answers ]

I've cleand replaced the carb but it still keeps flooding can any 1 help:confused:

View more questions Search