Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Amana furnace
[ 2 Answers ]
Hi Everyone, I am having so much trouble, trouble shooting my furnace, I have a Amana Furnace, I noticed that the Burner is not staying long enough for the heat to blow through the vent. This is my observation, once adjusted the temp desired in the thermostat, the burner on the furnace...
Amana furnace
[ 2 Answers ]
I misplace the wiring diagram and installation manual for my Amana Furnace. Any chance someone, website may have a good source for that: Mod # GUCO70B40A, Serial # 9110104173, Mfg # P9114303F Suggestions for a fix would be appreciated also: Having problems starting. The igniter works fine...
I have an Amana 80+ furnace.
[ 1 Answers ]
When the temperature reaches the desired setting, the gas burners turn off as they should, however the fan continues to run and blows cold air. The temperature dips well below the thermostat setting, but the burners do not turn back on and the fan continues to run. I also notice a flashing red...
Amana Forced Air Furnace
[ 2 Answers ]
My two year old furnace does not come on when the thermostat indicates that it should: i.e. 2 degrees below the ambient room temperature. I have set it for 72 degrees but it gets as low as 64 degrees before it will finally come on. I have replaced the thermostat with a brand new honeywell...
Old Amana furnace needs new blower
[ 7 Answers ]
Happy to be here. Two part question- I own an old Amana "Air Command" gas fired forced hot hir furnace. Model # GHE140DJ-4. It's circa 1979. Blower is 2-speed, capacity is listed @ 112000 BTU /hr. The fan would not come on during auto, but I managed to make it spin under "on" position by spinning... View more questions Search
|