 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace is blinking 4 times saying open limit switch
My furnace is blinking 4 times indicating that the furnace has an open limit switch. I changed the switch and it is still blinking 4 times indicating the same thing. What else could be wrong or what can I do to fix this problem? ITS COLD!!
|
||||
|
||||
|
In the line going to the limit switch was there a little fuse, a small thing in the wire that looked like a small firecracker, it will be close to the limit?? That is a roll out fuse but works in line with the limit switch. And I am sure it would give the same 4 blinks. To check this you can use a short piece of wire to jumper around the fuse. If that is the problem DO NOT LEAVE THE WIRE ON AS A JUMPER TO MAKE THE FURNACE RUN. That is a safety fuse and there is something wrong or it would not have blown, it could have been a down draft or something similar but do not take the change.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm sorry but I don't know what brand of furnace I have. so here's the problem... a couple of days ago I noticed my furnace was blowing cold air so I went to check to see if the pilot was out... well I have and automatic ignitor. So I carefully followed the instructions for resetting the furnace....
I have a furnace with the B18099-13 control board. The fan blows constantly whenever power is applied. The status LED on the control board indicates "OPEN LIMIT SWITCH" Where are the two limit switches located? On board or off? Are there any tricks, quick-fixes, or "band-aids" for this...
I've raised this issue in other forums. I have a high efficiency furnace that has worked flawlessly for the last four years (the house was built in 2000). This year we had to have the circuit board replaced. After that there was a problem with the blower, i.e. it wasn't shutting down after the...
I have a Concord 80 Plus Gas Furnace. I am starting the furnace for the winter and it gives me a LED code of open limit switch or limit switch circuit. Everything seems to work fine up until the point where the blower needs to turn on. I had the same problem last year but got a tech to fix it. I am...
I have a goodman furnace and just the other night I noticed the house wasn't heating, I checked the furnace and the indicator light suggested vent blockage checked the vent stack that leads to chimney and found 2 dead birds in stack removed them and started furnace, thought I had it fixed. All...
View more questions Search
|
