Ask Experts Questions for FREE Help !
Ask
    lexefx's Avatar
    lexefx Posts: 31, Reputation: 1
    Junior Member
    		  
    #1

    Jul 13, 2011, 05:48 PM
    Troybuilt TB70SS weed eater - How to remove the cluch housing?
    My clutch housing just free wheels. Troybuilt told me to drop a rope in then plug hole to stop the piston close to
    TDC - my problem is my clutch housing just free wheels - its not connected to the motor driveshaft at rest.

    It doesn't appear to have any serviceable fastener in the cluch shaft receptical (where the main driveshaft of the weed eater connects. I am stupmed. Any ideas?

    This is for a starter assembly replacement. Item 35 is what free wheels, and is the last step to get the starter housing off.

    http://www.ereplacementparts.com/tro...267_27463.html

    Thanks in advance
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Jul 13, 2011, 08:23 PM
    There is probably a torx scew inside the end . Probably T10 or T15.
    Luck
    lexefx's Avatar
    lexefx Posts: 31, Reputation: 1
    Junior Member
    		  
    #3

    Jul 14, 2011, 06:48 AM
    DG - It was a T20 - your right - Thanks!
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #4

    Jul 14, 2011, 06:33 PM

    Your welcome.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search


Check out some similar questions!

Weed Trimmer(weed eater) [ 3 Answers ]

I need step by step help on re-installing a (recoil) starter rope on a weed eater. If by chance you have diagram of how to put it on , I sure would appreciate it , any info will be appreciated ty denise

How do I replace the pull rope on a troybuilt weed eater [ 3 Answers ]

Trying to replace the pull rope on my troy built weed eater.I don't have a manual thus needing to know how to start.

Weed eater [ 3 Answers ]

My weed eater starts on choke for 2-3 seconds then stops

View more questions Search