 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
High efficiency 5000 heat pump Tempstar
I am trying to find out if anyone out there would have any idea where I could get a wiring diaghram for a Tempstar Heat pump Called High Efficiency 5000. I believe this is a older model, and there are many out since this one. But the unit is good and I would like to use it. Any suggestions??
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have an above ground pool. When the filter is on the pressure usually stays around 30. Now it is registering as high as the gauge will go. I lost my manuals in Katrina. Can anyone help? Sorry.. the pressure usually stays at 15 now it is as high as it will register!
I have a two year old Goodman unit that does not cool properly. The suction line does not get cold - barely slightly cool. It is a 3-ton high efficiency unit with a 5-ton coil. The orifice size was changed from a 74 to a 73, which is now the recommended size. The pressures were 72 and 190 on a 90...
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
I had a wall-mounted unit installed in a room in may of this summer. In the middle of the night the heat shut off and has not come back on since. It is an Amana, electric heat with heat pump unit. The cooling works, the heating setting does not blow air at all. When I remove the cover it says...
Equipment: Trane XL1400 4 years old Auxilery heat: Strips... 2 -60Amp circuits Filters changed every 30 days I cleaned outdoor unit summer 2006, as every year. Thermostat: Honeywell Chromotherm II Problem: I have been noticing at times the aux heat kicking in at times I think it should not....
View more questions Search
|
