Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
York Furnace: Only one of four burners light
[ 1 Answers ]
York (Model: P4HUA1ZN06401B) vertical natural gas furnace. Observed that the burner on right, by the glowing starter, starts properly but the other three burners do not light and since the thermocouple on the left does not start, the gas is stopped in about 5 tyo 10 seconds. I cleaned all four...
I have a Rheem Corsair 90%, burners intermittent, replaced about everything...
[ 0 Answers ]
5 yr old corsair 90%er burners flash on, then burp, and run then burp, then kicks out and goes to lock out... I've replaced about everything... control panel, pressure switches, gas valve (twice), heat sensor rod, hot wired around thermastat...
York diamond 80 furnace last two burners won't light
[ 1 Answers ]
I have a York Diamond 80 furnace. The first two burners light up but the others won't. After about 4-5 seconds the burners turn off but the fan is till running and blowing out cool air.. What do I need to do other than calling someone.. Please help.. Thanks
York burners won't ignite mod P3HU 9 yrs. Old
[ 3 Answers ]
When t-stat calls for heat the combustion blower starts, the glow plug glows but gas valve doesn't open and burn doesn't ignite. The combustion blower continues to run. Is this a problem with the pressure switch? Does it need to be replaced? :confused:
Intermittent loss of Hot Water
[ 1 Answers ]
I have a water heater problem. It's a standard gas water heater, Rheem. The water in the moring was not as hot as normal, like the water heater stopped working overnight. I checked and the pilot light was out. I relit the pilot and the burner fired up and was working fine. The next morning the... View more questions Search
|