Ask Experts Questions for FREE Help !
Ask
    alexzar14's Avatar
    alexzar14 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 19, 2007, 12:52 PM
    Sequence of events in a heating system described...
    Hello, here is the picture of a heating riser digram consisting of a Teledyne Pennant 400mbh-input heating boiler, inderect Turbomax hot water heater, and a single zone for radient heating.
    Application is for a spa/massage/therapy (cellar floor).

    What would be the controlling wiring layout in system like this? What would a radient heat thermostat be connected to? How is all this interacted with temp. sensors on radient heat manifold, what gets the priority and what does what step by step...
    And how is the hot water heater made to have a priority in this?
    Attached Images
     
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 21, 2007, 07:55 PM
    Call an engineer. We try to help with furnace failures but designing a wiring sysyem is asking a bit too much.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heating system isn't heating.. Is there a pilot that needs lighting? [ 1 Answers ]

I am renting a home that is 50 years old. It has recently turn cool, low 30s. If I turn the heating/air switch to heat and 70 + degrees. All I get is cool air coming out of the air vents. Can someone tell me what things I should do before calling heating specialist?

Heating system [ 1 Answers ]

1. What would cause my copper hotwater pipes to blacken with a sooty powder? We removed a wall during remodeling and found the pipes with a black sooty powder. It comes off on to your hand when touched. Plus, we found a plug with blackened cooper also..? Any help would be appreciated. 2....

Hydronic heating system [ 2 Answers ]

I'm a licensed electrician that's been asked to hook up a 4 zone hydronic heating system which I have never worked with before. It's a mighty therm boiler model HH-PH, using RIB2041D relays 24 volt thermostat and a side wall vent. I've got all the 120 volt hook-up done and the relays hooked in...

Burping heating system [ 5 Answers ]

Last month I had several visits from my oil service people because of no heat in one of my zones (oil-fired, hot water, 3-Zone system). The solution was to bleed the system until the line essentially burped. Since those visits I've had to burp the lines myself (watched the techs carefully when they...

View more questions Search