Ask Experts Questions for FREE Help !
Ask
    neubs's Avatar
    neubs Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 10, 2011, 03:21 PM
    Plumbing tools calking tools for lead (new)to buy?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Feb 10, 2011, 03:26 PM

    HI Neubs...

    Your question isn't clear... please explain in better detail, OK?

    If you are asking about where to buy caulking tools then you can buy them online or at any plumbing supply store... ;)

    Here's a couple sites:

    Plumbing Caulking Irons for Lead & Oakum Pipe Joints

    http://www.fwwebb.com/pdf/2003pasco/pas_c-26.pdf

    Mark
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Feb 10, 2011, 04:42 PM

    Alternatives to Lead Seal in Cast Iron Drain Pipes | eHow.com but I think we already answered this in a dup post
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

'must have' tools [ 11 Answers ]

So all you do-it-your-selfers out there, my question is what would you say is your 'must have' tool, the one you would not do without? With Christmas coming up I thought this might be a very helpful thread to start. Thanks.:)

Tools. Got any? [ 21 Answers ]

Mechanic's work light: Primarily intended to amuse those watching the work rather than actually helping the person that is doing the work. Hack Saw: One of a family of cutting tools built on the Ouija Board principle. This saw can transform human energy into a crooked, unpredictable...

Tools for sweating [ 2 Answers ]

A few questions about copper and sweating... Does the hand-held butane torches work for sweating copper (leadless solder)? If so, any special precautions? Or is propane the best... My job has small scope: 6 fittings on 1/2 inch.

Power tools [ 1 Answers ]

I own a dewalt table saw model# 744. Somehow the motor is not square to the opening anymore. Can anyone offer some insight on how to remedy this situation

View more questions Search