Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can anything be used to soften very old pipe dope on brass pipe fittings?
[ 16 Answers ]
Brass water valve needs to be replaced, it's in a very tight location to afford a large wrench good grip and leverage. It is cracked -probably done by me trying to muscle it out. So do I have to cut it out?
Plastic compression fittings how to
[ 3 Answers ]
Which is the proper orientation for a plastic compression ring? Large end towards the outlet pipe or into the compression nut?
Compression fittings not in far enough
[ 1 Answers ]
I just fixed my old dishwasher line and I had to cut out a leak. I had enough copper tubing to just reroute the remaining tubing into the valve stop. However, it is an older house and the outside diameter of the tubing was a bit wider than what we use now. I got the nut on as far as I could and...
Teflon or Pipe Dope for 1 1/4" Water Pipe
[ 7 Answers ]
I am building a project that uses several joints of 1 1/4 " galvanized pipe, including elbows and Tee's. The unit will be plumbed into my 50 psi water system. What is the best way to seal the pipe joints? I have assembled the unit and tested using teflon pipe dope and had several leaks. View more questions Search
|