Check out some similar questions!
Convert 240 volt 3 phase to 220 volt single phase
[ 2 Answers ]
Hi I have a 3 phase 250 volt 30 amp socket .I want to know if I drop one leg and change the receptacle . Can I plug a 200/230 volt 48/42 amp miller welder in to it ? Do I just wire nut the extra wire or pull it out of the panel ? Thanks mike
Is equipment cheaper to run on 480 VOLTS OR 220 VOLTS 3 phase
[ 1 Answers ]
I have 2 refrigeration compressors. One 5 h.p. 480 volts, 3 phase @ 4.5 amps. One 5 h.p. 230 volts 3 phase @ 20 amps. Which one will cost less to run assuming electric costs are same?
Can 220v-1 phase table saw be powered from a dryer outlet
[ 6 Answers ]
Hi I have a Delta 3 HP -220 volt single phase table saw in my garage but do not have a 220 volt outlet in the garage. I was considering making an extension cord to run from the garage to the nearby laundry room where I could plug into the 220 volt clothes dryer outlet. The dryer has a circuit...
Trying to connect 220v 3phase lathe to 220v dryer outlet.
[ 12 Answers ]
I want to connect a 220v 3 phase lathe (2hp Baldor motor 2 pole plug with ground) to a 220v 3 wire dryer wall outlet. The lathe plug has black, white and green wires. The dryer outlet is black, white and red. I want to make an extension cord with 12/3 wire, male dryer plug on one end and female...
Can I rig 2 generators (220v bi-phase) to get 220v three fase
[ 2 Answers ]
I have two 6000 watt generators that are bi-phase and want to run a 5hp motor that is 220v / 3 phase. Is it possible? How would the wiring go? I'm in Mexico and can't find a rental... well I found varios but no one that can hook up my motor. View more questions Search
Add your answer here.
|