Check out some similar questions!
Replacing bedroom hollow doors with 6 panel pine doors.
[ 4 Answers ]
I am replacing my bedroom hollow doors with 6 panel pine doors. My problem is that the 6 panel pine doors are not fitting properly. When I hung one door with the same size hinges I was able to put the screws in the same holes as the old ones but the door will not close. The new door is about...
Installing double doors
[ 20 Answers ]
I have a set of hurricane resistant 15 pane french doors I want to install in replace of my 30" wide single door. I have a total of 65" of space to work with and my doors measure 30" each. It is a load bearing wall with just the roof overhead gable end. Can I replace my original 30" wide door...
Installing Double Doors in Basement Wall
[ 4 Answers ]
currently, I have a basement door leading to my backyard that id like to widen to accommodate a sliding glass door. This wall is load bearing as the floor joists run to it. Currently, there is no lintel/header. My existing door runs all the way up to a double sill plate that runs around the...
Installing fixtures over garage doors
[ 4 Answers ]
We just installed three single garage doors. Would like to put two light fixtures on either side of doors. Question: How high do I install light fixture or how low from top of garage door? Thank you
Installing Fiberglass Entry Doors
[ 2 Answers ]
I am in the process of getting some new pre-hung fiberglass doors. I was told (by my brother) that I can’t use storm doors with fiberglass (or metal) doors. It turns into a greenhouse, and stuff then warps, including the parts of the storm door itself. Is that true? Thanks, Brian View more questions Search
Add your answer here.
|