Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Cutting pipe at an angle
[ 7 Answers ]
I need to occasionally cut round pipe at an angle but always have trouble. Is there any way of doing this by marking out line with a pattern or similar device? The only cutting devise I have is 9" angle grinder. The pipe can be up to 4"diameter and wall tgickness from 1/16th to 1/4 inch. Any help...
Velocity at 30 degree angle
[ 3 Answers ]
I want to check if I am on the right track. Question: Santa loses his footing and slides down a frictionless snowy roof that is tilted at 30 degrees. If Santa slides 10m before reaching the edge, what is his speed as he leaves the roof? Would I use ax=g sin (theta) and then take my results...
One inch gas pipe
[ 3 Answers ]
What length of unthreaded one inch gas pipe should be exposed when stubbed out from a finished wall
Cutting a pipe on an angle
[ 4 Answers ]
How do I cut a pipe on a angle?
Installing ceiling fan on 70 degree angle
[ 3 Answers ]
Help I am trying to install a ceiling fan on a sloped ceiling, 70 egree angle. I am just replacing the one the builder put in, but I can't find one that will fit that steep of a sloap. The one I am trying to install is a harbor breeze model from Lowe's. Then I went to Home Depot and asked what... View more questions Search
|