Not your question?
Ask your question
View similar questions
Check out some similar questions!
Physics (Current and Parallel Forces)
[ 3 Answers ]
Hi HelpDesk: Please I need help how to figure out these problems: 1) An auto engine of mass 295Kg is located 1.0 m from one end of a 4.0 M work-bench. If the uniform bench has a mass of 45.0Kg, what weight Must each end of the bench support? 2) There is a graphic like:
Can I use parallel thermostats in a 1-zone system?
[ 3 Answers ]
Bought an old 3-storey house in Maine, heated with gas forced-hotwater radiators. There is only 1 zone, with the thermostat in a 1st floor front room with little traffic and away from any radiator. When the t'stat calls for heat, it takes so long for it to register at the t'stat site, that the...
Parallel Thermostats
[ 3 Answers ]
I Am installing baseboard electric heat in 2 rooms in my basement on a new 20 amp 240v circuit. In the first room I'm putting 1 1500 watt heater and 1 1250 watt heater for a total of approx 11.5 amps (connected parallel). My question is this: Can I run a parallel connection from the first...
Writiing equations with perpendicular lines
[ 2 Answers ]
I don't understand how to write an equation with a perpendicular line. The book does not have an example. Write and equation of aline through (4, 5) that is perpendicular to y=1/2x & 3. I have been doing equations when there are two sets of ordered pairs. This only has 1. Please help.... View more questions Search
|