Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Large bathroom mirror
[ 2 Answers ]
Hi I recently had a large bespoke mirror fitted on my bathroom wall. The mirror is surrounded by tiles. As it was supposed to be made to measure I was unhappy with the gap between the mirror and the tiles - about 8mm - 10mm. The local shop who supplied and fitted the mirror sent someone...
Cracked Bathroom Mirror
[ 2 Answers ]
I have a large bathroom mirror----6 foot long and 3 ft 2 inch high. There are four screws in each corner to help hold the mirror. Each screw is surrounded with by a small scalloped circle. The previous tenants evidently screwed the lower left screw to tightly and there is a crack 21 inches long...
Installing a lighted mirror in my bathroom
[ 3 Answers ]
I am replacing a mirror in a bathroom with a lighted mirror. When I removed the previous mirror there were 3 wires hanging there. 2 seem to be white and 1 black. The black is hot and when I put a meter on either white and the black I see 118V. The meter does not indicate a short between the 2 white...
Bathroom mirror on tiles with borders
[ 1 Answers ]
If you can see in the picture attached to this email, There is a picture of a bathroom, this is how my tiles are set up. There are 2 borders that stick out of the wall, the top one sticks out further than the other. In the second picture attached, there is a mirror from a shop. (the middle...
Mirror tiles in a bathroom
[ 0 Answers ]
Hello Experts I am planning to mirror tile the walls around the bath/shower area in my bathroom. I will probably use 30cm sq mirror tiles from Ikea. These come with s/a pads which I assume will not be up to the job in a bathroom. I found from searching this forum that there is a product... View more questions Search
|