Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing blower motor - matching new to old?
[ 2 Answers ]
I just pulled out my old blower motor and am going to replace it. Do I have to match all the specs, i.e. must my new motor be 115v, 1phase, 1050rpm, 1/3hp, 9.9amps, 60hz. Can I/should I choose a motor with greater rpms or greater hp? Thanks for the help, Alex Ps - I decided to replace...
Matching wires on new honeywell thermostat
[ 1 Answers ]
My old thermostat was janitrol HPT 18-60 and wires were: Y (yellow) G (orange) R (Red) O (orange) W2 (white) E (Black) C (Blue) I just bought a Honeywell #RTH6300B. Their wires are: G,W,Y, R,RC. How can I match them up? Do I need the "O" on the old one? We are only getting hot air now by...
Matching A/C units
[ 7 Answers ]
Do I have to match the outside unite with the inside unite? I have a Rudd sys. Right now the heat pump outside is gone out. Do I have to replace with the same brand or can I go with an other brand? I'm in Dallas/Ft. Worth Tx. Do I need to go back with Heat pump or can I just go back with a a/c...
Water pump/pressuretank matching
[ 1 Answers ]
Trying to find out if I made a mistake. I have a 85 gal. tank hooked to a 1/2 hp pump. Cycle time is over 7 minutes before pump comes on and five minutes before pump shuts off.
Trane Variable speed w/hot water coil/Ac wiring ?
[ 3 Answers ]
I've read many of the previous questions/answers, but haven't found what I need. Low voltage wiring is not my strong suit. My AHU has a hot water coil in it, that I plan to heat with a Voyager water heater. It has an A/C coil, and that works fine. Previous answers have said that I should find a... View more questions Search
|