Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Armstrong Ultra V
[ 1 Answers ]
Armstrong Air Ultra V, 4 yrs old: Problem: *Igniter comes on with bright red/blue flame *Burners then come on *Fan blower comes on *Shortly after blower comes on, burners go out, and blower continues to run *Igniter comes back on *Burners then come back on *Then Burners go out again...
Armstrong-Air Gas Fired Furnace G1D91AU NOT heating properly!
[ 6 Answers ]
I have an Armstrong-Air Gas-Fired furnace G1D91AU and maybe a programmable thermostat. The system is around six years old and it has started causing me problems this winter. The system has been inconsistent when following the preprogrammed settings. It will NOT warm above 70 degrees no matter...
Adding a Humidifier to a Armstrong Air Ultra V Tech 80
[ 1 Answers ]
I am installing an Aprilaire Humidifier 500a on an Armstrong Air Ultra V Tech 80 furnace. Where do I get the 24 VAC from the heating side of the furnace to feed the humidifier control?
Armstrong Ultra SX 80 Replacement Pressure Switch
[ 2 Answers ]
I need to replace my pressure switch made by TRIDELTA. I believe it is part number PPS10090-2615. It also has the following numbers: 046317/0014/B and 44819-002. Does anyone know what the specs are for this pressure swtich? Is there a less expensive option for replacement? Any feedback...
Armstrong Ultra sx 80, pilot light lit, but heater doesn't turn on
[ 4 Answers ]
We have a propane heater. We have propane in the tank. There is air blowing through the vents, but there is no heat. Usually, there is a clicking sound in the thermostat, a whumph sound in the heater and the heat comes on. Now there is no clicking sound and no whumph. Consequently, no heat. ... View more questions Search
|