Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Carrier/Bryant Furnace control board .
[ 9 Answers ]
I replaced Carrier/Bryant board and the led is flashing rapidly.. what can be wrong? It looked like there's problem with polarity,but everything is fine, the led is still flashing.. uff.. Led Code: Continuous on rapid flashing-Line voltage 115 polarity reversed.If twinned,refer to twinnig kit...
Carrier Circuit Board - Bad Resistor
[ 4 Answers ]
I have a Carrier Furnace which has a bad circuit board. I noticed that the resistors on the printed Circuit board look burned. The circuit board is a CES0110057-00 and the resistors reside on R57 and R58. I would like to replace the resistors but not sure how to identify the resistance level. ...
Carrier Blower Control board knocked out by lightning
[ 2 Answers ]
I would like to know how to hard wire the blower on my Carrier AC unit until I can get a new part for the blower control board? Also where can I shop for this board? Following a lighting strike, the fan stopped blowing even though the outside AC unit still ran. Thanks
Help Replacing Carrier Circuit Board HK42FZ004
[ 2 Answers ]
I have a Carrier gas furnace that is not getting gas; the rest of the cycle runs properly, including the HSI glowing, but there is no gas to light, so the system shuts down and I get a 21 error code (gas lockdown). I am showing no voltage to the gas valve at the point in the cycle when control...
Carrier Gas pack circuit board part #
[ 3 Answers ]
Can anyone suggest/cross-reference the part number for my circuit board? The model number for the unit is 48SS018-060. Thanks. View more questions Search
|