Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Civic code 9 (CYP) Sensor Error
[ 8 Answers ]
Hi I have a problem with my honda civic... Its popping out code 9 which is the cylinder position sensor (CYP)... I bought a new distributor for it but is still popping out the error code... was told I might need to replace wiring... so I was woundering if I change the engine harness will it be...
1990 Honda Civic rough idel and dead cylinder
[ 5 Answers ]
My 1990 Honda civic 1.5 is driving me nutts. It idels rough and when you pull the #2 spark plug wire it does not change the idel or anything. I put a full tune up on it, it has spark on all wires, compression is great on all holes. When you get the rpm's up it smooths out and runs great. I pulled...
92 Honda Civic cylinder firing order?
[ 4 Answers ]
I recently replaced the ignition coil, distributor cap, and rotor on my 92 honda civic. This fixed my initial problem of the car starting; however it seems to be running a little rough and a little gutless. So I am not sure (if when I initially was moving about and replacing things - yes I could...
Honda civic code 9 cyp sensor how to repair
[ 1 Answers ]
I got the engine light coming on at different occasions not always, checked and got error 9, as per honda manual I tested the points on connectors for cyp, on male connector, I got right ohmage reading, on female I get a open reading,meaning from one point to ground there is continuity, My... View more questions Search
|