Ask Experts Questions for FREE Help !
Ask
    wrightjon's Avatar
    wrightjon Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 8, 2008, 08:57 PM
    Programming Honeywell VisionPRO TH8000 thermostat
    How do I go about entering the temperature for my backup heat source (in my case, gas) to kick in? I believe it was set at 35 degrees, but I want to confirm.
    Thank you
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 8, 2008, 09:27 PM
    Here is your informationYour backup heat soure is the second stage.

    http://customer.honeywell.com/techli.../69-1896EF.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell th8000 [ 10 Answers ]

I have a th8000 that is locked up. I have tried new batterys I have also tried to pull the memory battery out and still nuthin I bought this house about 6 months ago and it came with it, is there any way of getting it unlocked, these aren't cheap units if not ill go with something else, also does...

Honeywell VisionPRO 8000 Installation [ 5 Answers ]

Hi Everyone! We just finished building our new home and didn't think about thermostats along the way. There is a simple digital thermostat installed at this time but we wanted a programmable one. I attempted to install it today but the compressor wouldn't cut on. I've installed thermostats before...

Honeywell TH8000 thermostat [ 3 Answers ]

This thermostat was installed only 8 months ago and has worked fine until last night. It began a humming sound and the thermostate vibrates. What is causing this? The heater is working fine and all displays are normal. It is just this loud sound that is emitting from the thermostate itself and...

Honeywell TH8000 intermittent [ 1 Answers ]

I have a few months old Lennox heat pump with Honeywell TH8000 thermostat. Most of the time the thermostat works great but once every two weeks or so the inside temperature on the unit says 75, the thermostat is set to turn on heat at 72, and the heat comes on! The programming is set for manual,...

Honeywell TH8000 Thermostat [ 8 Answers ]

When this thermostat call for aux. heat, it reads aux. heat on the pad but no heat. The aux. heat works in manual mode. I think a setup code is wrong since it has never done right. Could someone help.

View more questions Search