Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Vanity Sink trap
[ 4 Answers ]
I'm installing a bathroom sink with very little clearance to place the trap below the waste pipe. Will this present a problem draining water or causing gas fumes? There will also be extra bends involved. Please refer to my sketch. Thanks. Jay
New vanity: trap won't reach wall drain stub
[ 3 Answers ]
We replaced a vanity top and sink with a new vanity top having an integrated sink. The new sink is offset horizontally about 1 inch from the old one. Turns out the old sink was at the limit for trap reach; the new one is over further still, so it seems impossible to line up the j-bend portion...
Options for Dishwasher Waste line
[ 1 Answers ]
In the past, I have always hooked up the dishwasher waste line to a sink drain waste "T" or to a garbage disposal "T". Is there an approved way to connect it directly to the 2" drain line that the sink is connected to? Or should I stick with what I have been doing. In the current situation,...
Can I vent from
[ 3 Answers ]
I am planning to install a bathroom in a small dormer room on the third floor of my old house. The room sits between two plumbing stacks. The original one with cast iron pipe and a newer one with ABS pipe. I wish to locate the toilet and shower stall on the wall with the cast iron stack. I...
Vanity drain line and water supply
[ 5 Answers ]
Tom, I have a couple of questions for you. I am installing a double simk vanity. What is the standard for the drain line coming through the wall, as far as how high off the floor, and how far through the wall should it protrude for the trap adapter etc. same thing for the supply lines coming... View more questions Search
|