Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Splicing pvc pipe
[ 7 Answers ]
I need to connect a "T" to an 1.5" underground pvc pipe. To fit properly a 1" space must be cut in the pipe. The "T" is obviously larger than the opening, how can this be done?:mad: :confused:
How many cables in a PVC Pipe
[ 1 Answers ]
I just ran my 100Amp #2Ga - 4 conductor wires (which all 4 conductors were in a jacketed cable) in a 2" PVC pipe, from my new Sub Panel to the main 200A house panel in the garage (only about 6 ft in the PVC pipe, the rest of the run is in the wall) My question is, I need to run another 12/2...
Copper to pvc pipe
[ 7 Answers ]
We are trying to install a water system in our home and need to know how we go from copper pipe to pvc pipe.
Drilled into PVC Pipe
[ 2 Answers ]
While drilling a hole to hang a towel rod in a first floor bathroom, I drilled into the PVC waste line that comes from the upstairs bathrooms. I cut away a section of the drywall and can see I hit almost dead center into a 2 or 3 inch PVC waste line. The hole is approx. 1/2" in diameter. Is there...
PVC to Copper Pipe
[ 3 Answers ]
I am remodeling a bathroom. The existing drain pipe is 1 1/2" copper tubing. What is the best way to connect a 1 1/2" PVC to 1 1/2" copper tubing? View more questions Search
|