Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Thermostat Wiring - Green Wire to B terminal
[ 1 Answers ]
I just replaced an old Honeywell mercury thermostat with these series of letters and numbers on the inside: HB2 T222A 1012 1 with a new RTH2300. There were 3 wires in the old thermostat, red connecting to R, white connecting to W, and a green wire connecting to B. Where do I put the green wire in...
How much wire should be in contact with a terminal screw?
[ 3 Answers ]
I'm attaching a thermostat, and have the correct wires to the correct terminals, but because I'm a bit afraid of electricity, and therefore don't know much, I'm not sure how much of the stripped wire needs to be in contact with the terminal. Also, the wire seems all snug, but the minute I start to...
I have a new blower motor with a extra wire,what do I do with this wire.Going from 3
[ 1 Answers ]
I bought a new blower motor for my furnace,The old blower motor was a 3 speed and new motor is a 4 speed.The place I bought it told me to hook up white on white,black on black,red on red.And leave the orange wire hanging.I have no high speed for the ac.Is there some where I need to install the...
Connecting a #14 stranded wire to a #8 screw terminal
[ 4 Answers ]
What are 5 products that could be used to connect a #14 stranded wire to a #8 screw terminal?
Yikes! Does the blue thermostat wire go to the C terminal?
[ 11 Answers ]
Hi. I'm trying to install a Honeywell RTH7600 programmable thermostat. I've detached my old thermostat, and I'm trying to figure out how to match up the wires. It's heat and air conditioning, and the old thermostat was a pretty basic, older round variety (also honeywell). Problem is that I... View more questions Search
|