Ask Experts Questions for FREE Help !
Ask
    jocko009's Avatar
    jocko009 Posts: 6, Reputation: 2
    New Member
     
    #1

    Jun 9, 2007, 05:00 PM
    Measurement for rough in
    I need to know the rough in, measurements for a toilet and shower(36" squire)
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Jun 10, 2007, 07:16 AM
    The measurement for a toilet is 12 inches out from the wall to the center of the closet flange. With a center drain the shower base should rough at 18" to center out from each wall if it's in a corner or 18" off the wall if not. Best policy is to set the base where you want and mark the center of the drain. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Flow measurement [ 1 Answers ]

We have 500 mm Dia water GRP pipe with 30 C temperature and 1 bar pressure gauge . If we will take 100 mm tapping from the pipe to same level , how can we calculate the flow in the tapping if we assume the end pressure of the tapping is zero bar or atmospheric pressure

Window measurement [ 3 Answers ]

I want to install double hung windows in my home. I'm buying the windows from home depot. Question #1, when measuring windows do I give exact measuring example one windows measure w-29 3/8 - h-61 1/4 . Question #2 I live northeast what type of insulation I install in the inside of the windows. ...

What measurement should be given first [ 1 Answers ]

Once I ordered some replacement windows for a house. The discussion during this order was what should be given first the width or the length?

Measurement of colour mixing [ 1 Answers ]

Hi my name is Julie, and I am trying to find out the quantities need for mixing hair colour, I found out my hairdresser used Matrix Ultra Light Blonde Series, UL-A Ultra Light Ash Blonde and U-LN- Ultra light Ash Blonde with 40 ccl, could anyone tell me how much cream and how much 40ccl.

Flatness measurement- aluminum [ 2 Answers ]

Visualize this, a piece of aluminum about the size of a credit card and about 3mm thick. Here is the problem. The part is machined under convention methods and received with pretty decent parrallelism. One side (large surface area) must be as flat. We mate a silicon wafer on this...


View more questions Search