Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Tying a basement floor drain into sump basin
[ 5 Answers ]
I am planning to install a floor drain in my basement which will discharge into my sump basin. Unfortunately, water on the floor will not flow into my sump since the lip of the liner is actually sitting on top of the slab, surpassing it by about a 1/4 inch. It was installed to collect water from...
Floor Drain Backup as well as catch basin
[ 8 Answers ]
I've looked through previous questions but have not seen anything pertinent to my problem. Last November we had our main sewer line rodded out as a preventative measure. They also cleaned out the catch basin. We had no problems with back ups etc. Now (in the dead of Chicago Winter) our...
Floor drain clogged 2 inch pipe tried everything
[ 4 Answers ]
My basement floor drain (from the hole in the floor to the main drain, about 15 ft.) is slow & sometimes clogged. When the clothes washer drains, water comes up on the floor, & slowly seeps down. I had a problem a few years ago with tree roots & big flood damage, had the old tile drain replaced...
Converting cast iron floor drain to shower drain
[ 3 Answers ]
I am adding a bathroom to my basement, which has partial (complete? ) plumbing already roughed into the floor (in 1976). Sewage lift station (vented) is 3 ft from 4" styrofoam plug (toilet), 4 ft from 1 1/2 inch cast male pipe end extending through floor (lav, have already added vertical vent...
Shower Basin Drain
[ 5 Answers ]
Hi, Tom was asking for more info but I wasn't registered, took care of that. NOW question is how is the flange removed from my old shower basin. I removed all tile sheetrock and basin to replace it with a four piece fiberglass unit. I can not remove the flange. Here is what I know: The drain is a 2... View more questions Search
|