Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Connecting neutral wire to ground wire in breaker panel
[ 3 Answers ]
Can the neutral wire be connected to the ground wire at the neutral bar in the breaker panel?
Yikes! Does the blue thermostat wire go to the C terminal?
[ 11 Answers ]
Hi. I'm trying to install a Honeywell RTH7600 programmable thermostat. I've detached my old thermostat, and I'm trying to figure out how to match up the wires. It's heat and air conditioning, and the old thermostat was a pretty basic, older round variety (also honeywell). Problem is that I...
Stranded wire to solid wire
[ 2 Answers ]
Is there any advantage, disadvantage, safety concerns, etc, in twisting, or not twisting stranded wire, such as fixture wire, to the solid wire before installing the wire nut? I always twist solid wire with linesman pliers, then install the wire nut. With fixture wire, I just twist the fixture...
12-gauge wire will not fit in 20A outlet screw terminal
[ 10 Answers ]
I have run conduit which came with 3-wire 12 gauge standed cable. I have it going to a 20A outlet, but all of the strands will not fit in the screw terminal. The breaker is a 15A. Can I trim a few of the 12 gauge strands to get the wire to fit onto the screw terminal? Are electrical outlets also...
How do I cut heavy gauge aluminum stranded 220 wire?
[ 2 Answers ]
I am replacing my electric range and it was connected to either a 60 or 80 amp circuit breaker that takes two slots in the panel. The wire is aluminum and both the wire in the insulation the bare wire are stranded. The insulation jackets are black and one seems to have a red stripe. The wire was... View more questions Search
|