Ask Experts Questions for FREE Help !
Ask
    mweya's Avatar
    mweya Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Feb 25, 2009, 06:32 AM
    Drive way gate
    What is the standard size of a drive way gate?
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
    		  
    #2

    Feb 25, 2009, 07:17 AM

    The bare min is 10 feet wide. 12 feet is obviously better. An asphalt spreader is 10 feet or 12 feet wide for driveways.

    A parking lot now a days are based on 9x 16 feet.

    A "standard" size is relative since many driveways gates are cut in factory to fit your measurements or on site.

    Signed 21 Boat

    If I Helped To Answer Your Question Please Rate My Answer
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Leaking gate valve [ 6 Answers ]

I have an 11/4" brass gate valve on the outlet of our boiler that is leaking on the top. Not out of the stuffing box, but just below out of a seam. What are the chances that there is some sort of sealant that I can put on there to stop the drip? Thanks in advance for your help! Bill

Gate repair [ 5 Answers ]

I backed into a 15 foot metal gate with wood fencing on the outside. The gate bowed about 2 inches. If I push it from the other angle will it straighten? Any other suggestions? It is made of two inch bars that were welded in place. Thanks for any help

View more questions Search