Ask Experts Questions for FREE Help !
Ask
    jgrhodes85304's Avatar
    jgrhodes85304 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 26, 2006, 10:10 AM
    How to replace heating element in Kenmoore dryer
    Hello,

    The heating element on my Kenmoore 86873800 dryer. I have the part but don't know how to replace it. Anyone know how? Thank You!
    andrewcocke's Avatar
    andrewcocke Posts: 439, Reputation: 22
    Full Member
    		  
    #2

    Dec 26, 2006, 07:10 PM
    Trying to remember... on my dryer, I think its accessed by remoing the control panel, and then it sits exposed. If that doesn't work for you, then you can try removing the back.

    There's a way.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heating element Kenmore 70 series electric dryer [ 6 Answers ]

When I start the dryer the heating element gets hot for about 5 seconds then blows a fuse. The dryer will still cycle, but never get hot again. I replaced the fuses and no luck. When I took the plate off I can see that it is getting hot. There are 5 coils and it appears that the top 3 coils are...

Dishwasher Heating Element [ 1 Answers ]

Does anyone have instructions to replace the heating element for a Kenmore Ultra Wash dishwasher?? I would like to do this myself. Thanks, Terri

Kenmore Dishwasher heating element [ 1 Answers ]

I need to replace the heating element in my 665.16512 Kenmore Dishwasher but I don't know how to remove the old one. Any hints?

Maytag dryer heating element wiring schematic [ 0 Answers ]

I have a Maytag dryer model#SDE5401AYW and it quit heating. We purchased a new heating element and went to hook it up but we have two gray wires that come from the wire harness at the motor that we have no clue where they go. My father-in-law took out the old heating element and didn't mark the...

How can I get enamel off heating element [ 1 Answers ]

Hi, I have a problem here. I left kettle on the electric stove for too long:( All the water boiled out & as a result the enamel from the kettle melted onto the heating element of the stove. Now I have enamel on the heating element. Any idea how I can get it out ? Thank you so much. Your help...

View more questions Search