Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Concern about circuit panel overload
[ 1 Answers ]
I'm in a process of adding a full bath and have a few concerns that I need your help with: #1. I have a 125 Amp circuit panel, and I did some calculation by adding up all the Amps for individual circuit breakers. I came up with: a. On the left hand side, the total of 155 Amps. b....
Bathroom circuit
[ 1 Answers ]
I am putting a new bathroom in basement and want to know the correct wiring. I will be running a 20 amp circuit with a GFI outlet, vanity lighting, and a small exhaust fan. I want to run the fan and lights on their own switches. Can the GFI and others run off same circuit? If so how do I wire...
Remodeling Bathroom, Need to move drains/vents
[ 7 Answers ]
I am in the process of remodeling my bathroom. I am moving all fixtures, toilet, sinks, shower, and jaccuzi. It is on a concrete slab, which I have mostly tore up. I am looking for some help with vents and drains for my new project. I attached a PDF with my proposed fixture layout. I...
Bathroom Circuit around corner?
[ 2 Answers ]
I am in the middle of a complete remodeling and upgrade of my 80 YO,5' x 9' bathroom. Toilet runs ditect into the 4" vent stack and will remain in the same place. New sink is circuit vented back to the stack and will be moved approx 15" further away from the stack but extending the 2" circuit vent...
Bathroom Vent fan GFCI circuit
[ 3 Answers ]
My NuTone fan says that it's UL approved for over shower use when wired with GFCI circuit. Would it be acceptable if I ran the fan power wire first through a plain face (non-outlet, but outlet sized unit) GFCI unit, through the switch and to the fan with nothing else on that circuit? I know that I... View more questions Search
|