|
|
|
|
New Member
|
|
Jan 5, 2009, 04:06 PM
|
|
Paper Won't Go Down First Time
One of my toiets seems reluctant to take down a simple piece of toilet paper after my daughter pees. Why is that? It seems to flush strongly and not back up at all. Then again, it did overflow one day last week, which is why I'm asking. I plunger it and it seems fine, but still refuses to flush down even four sheets of toilet paper some times.
|
|
|
Expert
|
|
Jan 5, 2009, 04:15 PM
|
|
Are you sure your daughter has only been putting toilet paper down the toilet? Mine does this too and It has never been a problem. If it is one small sheet of toilet paper then it is defying gravity mainly.
|
|
|
Expert
|
|
Jan 5, 2009, 04:22 PM
|
|
Are you on a septic system? Is it rainy where you are right now? This happens to my lower bathroom every winter during the rainy season.
|
|
|
New Member
|
|
Jan 5, 2009, 08:41 PM
|
|
Originally Posted by J_9
Are you on a septic system? Is it rainy where you are right now? This happens to my lower bathroom every winter during the rainy season.
No septic. Maybe it's magic paper.
Ken
|
|
|
Eternal Plumber
|
|
Jan 6, 2009, 07:20 AM
|
|
I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps and thank you for rating my reply.. Tom
|
|
|
New Member
|
|
Jan 6, 2009, 08:43 AM
|
|
Originally Posted by speedball1
I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH!!) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps and thank you for rating my reply.. Tom
Thanks... off to get dirty.
Ken
Tom;
Yer my hero of the day. Just finished and it's like a new toilet. Thanks again.
Ken
|
|
|
Eternal Plumber
|
|
Jan 7, 2009, 04:18 AM
|
|
Glad you got all fixed upo Ken. If we can ever be of service in the future we're as close as a click. Regards, Tom
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
LexmarkX6570 Paper jam display with no paper jam
[ 2 Answers ]
Hi,
I cannot get the paper jam error to clear - I have unplugged the printer, rebooted by laptop and still the error keeps appearing. There is no paper in the machine and the path is clear of any paper.
Any assistance would be very helpful!
Thank you.
Canon MP600 says no paper when there is paper
[ 1 Answers ]
I am trying tp print from Canon MP600 but get message "there is no paper. load paper and press OK"
There is paper in feeder - any idea of what solution might be ?
Thanks
Ph paper?
[ 7 Answers ]
I am within days of being 40 weeks pregnant. I do not want to run to the doctor every time I think my water might have broken. I have been I once because of my wetness and also asked about it once at an appointment. Both times I tested negative on the pH paper. The doctor has told me some women...
Paper jam
[ 1 Answers ]
I have a hp deskjet d1320. I was printing,and all of a sudden it said paper jam.I looked and there is not a paper jam.. how do I get my printer to unjam or to work?
View more questions
Search
|