Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How do I install a hot and cold valve stem for a bathtub?
[ 8 Answers ]
I need to know if anyone can send me the steps for installing hot and cold valve stems for a bathtub and if you can send a diagram of a normal bathtub bathtub and what each part is so I can help my brother-in-law and sister get their bathtub fixed. Please respond as soon as you can. Thanks.
Symmons Temptrol Shower Valve - Cold Water Only
[ 2 Answers ]
I have several 10 year old Symmons Temptrol Model A shower units. One has recently stopped all hot water. A second is warm at best. I was told by a friend (not plumber) that I need to replace the mixer valve or the part that stopps scolding. The reason being is the part wears out and defaults to...
Replace a Hot/Cold Water Stem
[ 1 Answers ]
I just purchased a Hot/Cold Stem 3h-8h/c For Price Pfister and I can't figure out how to get the cold water to on and off the way it did before. When I installed the stem it shuts on and off the opposite way. I'm looking to use these hold/cold stem replacements for both the hot and cold controls....
Mixing valve tub/shower with no cold water
[ 1 Answers ]
I'm flummoxed with a Delta, mid-1990's mixing valve. The valve has shut-off's via screw and locknut on cold and hot inlets, and I have good pressure there at both hot and cold side. But an inch-or-so away, at the main body holding the cartridge (I don't know the terminology, sorry), no cold...
Tub/shower valve stem
[ 7 Answers ]
Hello,I will like to know can a tub valve stem get restricted with sediment and block Water flow till you get hardly nothing or just a stream?It has been leaking for Quite a while now and has gotten worser.I already have an existing sediment Build up from galvanized pipes.I been tapping the... View more questions Search
|