Search:
Type: Posts; User: Sky4601
Search:
Search took 0.00 seconds.
-
Wow. Thanks for the advice about the filter, and I feel your pain with the pulley. But my concern is the tention idler, I just have to remove the star bolt?
-
Ok, I really feel like an idiot, I am trying to replace the power steering pump in my '99 Ford Taurus, and I can not get the mount bracket off the engine. It seams that there is something else...
-
You are the bomb as always, thanks Tx!
-
I got the socket, but with the A/C lines and insulation, along with the fender wall, I can not get the socket and wrench to go over the nut to use it. Make any sense?
-
No hole and no place for a drive/extention to fit.
-
-
I can not get at it with a socket, to close to the fender wall, do I need a special tool to remove the belt. I am needing to change the power steering pump.
-
Thank you Mr. Chuck. I could not figure out how to put it in the right category.
-
It will idle up to about 2000 rpm, runs fine, starts coming down, running good, drop to 700/800 rpm, starts spuddering, does not kill. And I am hearing a loud hiss, like there is a vacume leak,...
-
-
This is true, thanks.
I do maintenance for a living, so I have kicked out a few ideas to a few folks.
-
Can you turn the arm by hand? Check to make sure nothing has slipped or is sticking out under the rack, if the silverware basket is on the bottom, check it real good.
-
That would be my luck, trying to help someone else and I have the headache's. Thanks man.
-
Well I am not professional when it comes to mechanics, but I do know a thing are 2. I am already about at wits end with them guys. Thanks for your input, I will let you know what I find out.
-
Yes sir. That is what I was telling the guys that tested my old starter, there testers do not have a load on the bendix, they just check the silonoid and see the bindix kick.
-
If your piolt light stays lit, the thermocouple is good. Check the gas valve on the safety control valve at the unit, is it in the "On" position.
-
From what I could see, rings are fine in the area the starter is sitting. The car sat up for the last 3 months, been sitting for almost a year, but it stopping starting 3 months ago, got it from my...
-
Do you have room to elevate the new base? Or you can just go with tile and a floor drain.
-
No grinding, bendix kicks out, it was when we tested it at the store. I had the old one tested 3 times, 2 good, 1 failed. Do you think the motor is seized up?
-
New battery, new starter, sounds like a blender with nothing in it, it just spins. Will not turn motor.
|