Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: Stratmando

Search: Search took 0.12 seconds.

  1. If the Fan control switch is on the Fan, wire may...

    If the Fan control switch is on the Fan, wire may have pulled out of fan switch, fan switch may be bad, or capacitor issue.
  2. Answers
    7
    Views
    189

    #12 may be correct depending on Watts?

    #12 may be correct depending on Watts?
  3. Answers
    2
    Views
    100

    Control Panel/Printer/click or right click the...

    Control Panel/Printer/click or right click the printer, see what's printing, Delete Documents in Que. Or very similar. Good luck
  4. Answers
    7
    Views
    189

    Poster never mentioned Watts. Many/Most are 240...

    Poster never mentioned Watts. Many/Most are 240 Volts on a 30 Amp 2 Pole Breaker.
    15 Amp Breaker(s) should have tripped. 15 Amps @ 240 Volts is 2880 Watts.
    15 X 240 = 2880.
    At least the wire is...
  5. Stupid question, still in forward gear?

    Stupid question, still in forward gear?
  6. Answers
    11
    Views
    190

    You don't have to remove or unplug Microwave to...

    You don't have to remove or unplug Microwave to try on a different circuit, a Troubleshooter may remove microwave wire from breaker, then place wire on another Breaker. Swap temporarily so you are...
  7. Answers
    2
    Views
    116

    1221 E. Lancaster Ave

    1221 E. Lancaster Ave
  8. Answers
    2
    Views
    159

    Above, or try this:...

    Above, or try this:
    https://www.google.com/search?q=water+valve+tool&sourceid=ie7&rls=com.microsoft:en-US:IE-Address&ie=&oe=
  9. Answers
    2
    Views
    141

    Do you have a particular issue? Can maybe help...

    Do you have a particular issue? Can maybe help with that.
  10. Answers
    2
    Views
    106

    Don't know, If not printed on it, I would Google...

    Don't know, If not printed on it, I would Google Noma Thermostat, then Images, compare photos, or go to eBay, Amazon, other, and search Noma Thermostats, yours may show up? Good Luck
  11. Answers
    3
    Views
    140

    You can control 2 or more locations with Elk...

    You can control 2 or more locations with Elk Electronics WSV2 Electrically controlled 1" Valves, switch 1, the other, or both, add a Network controller, or other device to remotely control on and off...
  12. Answers
    2
    Views
    137

    https://dynamiccontrols.com/sites/default/files/20...

    https://dynamiccontrols.com/sites/default/files/2018-05/SHARK%20PMA_PMB_PMC%20Installation%20Manual%20Iss%207.pdf
  13. Answers
    2
    Views
    137

    You didn't get all the parts, Google a schematic...

    You didn't get all the parts, Google a schematic for it, or if you know where another is, you will want to see what else is connected, like Safeties , May have to jumper some connections.
    Throttle...
  14. I would turn on lights and look for voltage with...

    I would turn on lights and look for voltage with a Test light, Identify it as Tail light, or write all colors down and Function next to it.
    Remove lenses from both Old and new lights, will tell a...
  15. Question: Music

    by Stratmando
    Answers
    2
    Views
    141

    Steely Dan, Las Vegas, Mid 70's

    Steely Dan, Las Vegas, Mid 70's
  16. Answers
    1
    Views
    235

    There are places that rebuild Battery packs. If...

    There are places that rebuild Battery packs. If able to solder, you may buy the cells themselves and change out. Manufacturers use different methods for charging, 3rd terminal many times is for...
  17. Question: Warm wire

    by Stratmando
    Answers
    3
    Views
    174

    I'm wondering if they have a Water Heater that...

    I'm wondering if they have a Water Heater that requires a 30 Amp Circuit, but is on a pair of #12's. May never know since I saw no reply to your answer.
  18. Answers
    3
    Views
    192

    Many Batteries and Chargers seem to have 3...

    Many Batteries and Chargers seem to have 3 Connections, Believe the third may be used to sense Heat. At least what it looks like when you change the Internal Batteries.
  19. If files are lost and you don't plan on...

    If files are lost and you don't plan on Recovering them(Professional), Then you may be able to hit F11 repeatedly or similar at Start up, It may be Restored to Factory Fresh from a Hidden Partition...
  20. Milo, How about Stiebel and Titan? seem Popular...

    Milo, How about Stiebel and Titan? seem Popular in South Florida.
    I am a Long Time Electrician, Installed Many. I am not Convinced they are Better Either.
    They used to have a High failure Rate, and...
  21. Or leave the 3/0, Install a 150 Amp Breaker,...

    Or leave the 3/0, Install a 150 Amp Breaker, (need to do load calculations)call it a day, neutral is commonly a size smaller, as the Neutral carries the difference of the 2 Main Hots. If Black phase...
  22. Question: Central air

    by Stratmando
    Answers
    2
    Views
    187

    I wired one of my customers AC so if any...

    I wired one of my customers AC so if any Doors(could add windows, But they NEVER open) were open more that 5 Minutes it will shut off AC, so they are not Air Conditioning the Outside. Also, if Heat...
  23. Answers
    7
    Views
    360

    AND to the sides of the box. Good Luck

    AND to the sides of the box. Good Luck
  24. Question: A/C

    by Stratmando
    Answers
    3
    Views
    201

    Just match up the uF(Microfarads), and the...

    Just match up the uF(Microfarads), and the Voltage, Replacement can have a higher voltage, Be accurate on the uF. May have 3 terminals, pay attention to where the wires are connected, If it has 3...
  25. Answers
    7
    Views
    360

    Whoever does the Backsplash, especially if it Is...

    Whoever does the Backsplash, especially if it Is Marble or Granite for them to cut up to the sides of the box, and so the 2 screws can be inserted. See some who cut openings screws will not go in or...
  26. Answers
    3
    Views
    202

    Try new Batteries, or removing and reinsert...

    Try new Batteries, or removing and reinsert Batteries.
  27. Answers
    3
    Views
    194

    I think Batteriesplus also has individual...

    I think Batteriesplus also has individual Batteries, See if you can open pack without damage.
  28. Try new Batteries, or removing and reinsert...

    Try new Batteries, or removing and reinsert Batteries.
  29. The WD 40 was not for lubrication, it was to...

    The WD 40 was not for lubrication, it was to release the junk then blow out. Brake Kleen would surely Remove all. Then use a DRY Lubricant, Would wipe a coating of WD on the face of the lock(The...
  30. Answers
    6
    Views
    306

    Just to mention, If they were wired in Series,...

    Just to mention, If they were wired in Series, All Bulbs would have too work, if one bulb was broke or removed, others would not light.
  31. Spray down with WD 40 or something, wipe down, if...

    Spray down with WD 40 or something, wipe down, if it operates fine, keep it. Better than being dry. May not have wanted the Bright Brass to Tarnish.
  32. Question: Honda Accord

    by Stratmando
    Answers
    1
    Views
    209

    I would check Fluid, and change Tranny Filter,...

    I would check Fluid, and change Tranny Filter, Can't hurt, and may show little or lot of metal flakes.
  33. Answers
    7
    Views
    360

    The old way was to just take a hammer and break...

    The old way was to just take a hammer and break out the block behind it. If on a web, you can move over a little so it falls within a cell. Better is to take a Die grinder and cut out for the boxes,...
  34. Answers
    5
    Views
    366

    2 Common ways is T&M(time and materials), Not to...

    2 Common ways is T&M(time and materials), Not to be confused with T&A.
    I charge my Hourly and add 20% to Materials. I give Customer the option to buy the Materials, Need to get paid for my Time....
  35. Answers
    7
    Views
    324

    What did you find with Fuel Pump, and Regulator?

    What did you find with Fuel Pump, and Regulator?
  36. Answers
    1
    Views
    233

    Some have Throttle slides with 1 cable, some have...

    Some have Throttle slides with 1 cable, some have 2 cables, a pull and a push cable. Be sure routing does not affect Throttle Operation while turning handlebars.
    Can you describe more what you have?...
  37. Answers
    7
    Views
    324

    If You have no Manual, and you are cranking...

    If You have no Manual, and you are cranking Engine during test, 2 things you could do, Hook a wire to fuel Pump wire at fuel pump, add test light, when you jump the relay, or provide power in relay...
  38. Answers
    23
    Views
    552

    Certified doesn't always mean Competent or...

    Certified doesn't always mean Competent or Qualified. Change the Board and see if that is it? We call them Board Changers. I would do some testing before Buying a Board, Many are quick and Cheap...
  39. Answers
    23
    Views
    552

    Just a Note, If you don't hear door switch, it...

    Just a Note, If you don't hear door switch, it may be bad. Hearing it does not mean it is working or wires didn't come off switch.
  40. Spy Vs Spy?

    Spy Vs Spy?
  41. Answers
    6
    Views
    9,634

    You need a Neutral AND Ground. Ground is Not to...

    You need a Neutral AND Ground. Ground is Not to carry Current, If you did have a ground and Neutral, a Red and Black can Share a Neutral(a Multi Circuit), they need to Be Next to each other on Panel,...
  42. Answers
    3
    Views
    199

    On the 14' sides, if using 4' wide sheets, It...

    On the 14' sides, if using 4' wide sheets, It would take 4 to do 1 side, with 2' left over, you can use that 2' piece on other side. Which equals 7 sheets.
    For the Long side it would take 20 sheets...
  43. Question: Rectifier help

    by Stratmando
    Answers
    1
    Views
    195

    Old Rectifier may not work, Most I have worked...

    Old Rectifier may not work, Most I have worked with have 3 yellows(or other)from Stator, these Put Out AC Voltage, Going through a rectifier is usually 6 diodes, 2 for each yellow, 1 passes the...
  44. Answers
    7
    Views
    324

    You don't mention Fuel Pump Relay. I would get...

    You don't mention Fuel Pump Relay. I would get the Service Manual and follow the Fuel Pump On back. My Ford Truck has an Inertia Switch, so if there is Impact, It Interrupts power to Pump. Just need...
  45. Answers
    23
    Views
    552

    With power off you can check for continuity on...

    With power off you can check for continuity on the thermals, usually on the ductwork.
  46. Answers
    1
    Views
    173

    It would be Float sticking, or need adjusting,...

    It would be Float sticking, or need adjusting, Float Needle. Or debris keeping Float Needle from closing. If you dissemble, do not bent float parts, and be sure float is not hanging up on the side.
  47. Answers
    23
    Views
    552

    Wonder if it is contacts on timer, or Centrifugal...

    Wonder if it is contacts on timer, or Centrifugal switch?

    Even a failing door switch?
  48. Answers
    23
    Views
    552

    I find it is Usually 1 Part that goes Bad, Some...

    I find it is Usually 1 Part that goes Bad, Some are Cheap, others Expensive,
    If Capable, you need to Start at the receptacle, then follow the power in to the Dryer. Does the Door Switch click when...
  49. Sure hope she Recovered?

    Sure hope she Recovered?
  50. Answers
    8
    Views
    289

    Does the whole Wiring Harness need to be sorted...

    Does the whole Wiring Harness need to be sorted out? Swaping an engine only needs a few connections. The New Engine will have most of these to deal with. Wiring from the Stator to generate...
Results 1 to 50 of 500