Search:
Type: Posts; User: triptrop
Search:
Search took 0.00 seconds.
-
Hi,
Do I need to put teflon tape on the threads of a cleanout cover, or will screwing it in good and tight prevent any water from coming out?
Thank you!
-
From browsing the related posts I found that an extender flange might do the trick..
-
I'm finishing my basement. In the bathroom, the builder put in the floor flange flush with the cement floor. I believe it's glued to the pipe coming from below, because it wouldn't budge for me at...
-
I don't mind a little fun at my expense. :-) The lines that are tied together - your assumption is correct. Black to black, white to white, ground to ground, as though the wire was not cut.
I...
-
Another question/problem about my bathroom electrical.
What I ended up putting on the GFCI circuit (20 amp and 12 ga wire) is:
1. the outlet in the utility room,
2. the vanity light/outlet, ...
-
I'm wiring everything for my basement in the panel. There are plenty of open spots left. When I look at the existing wiring (for the rest of the house), all the grounds go to the block on the left...
-
I did. Turned out the problem was a bad connection in the fan unit. Works great now!
Thanks
-
I'm back with more "finishing basement" questions.
This weekend, I wired my bathroom. This is 20 amp service with 12 ga wire. For the bath fan/light, the power source came into the switch box (1...
-
I have two questions about electrical code for my basement finishing project.
The first question. In my bathroom, I'm putting a GFCI circuit breaker in the breaker box. It's a 20 amp. I would like...
-
I live on a gravel road and have a circular gravel driveway. One side of my circle has so much weed coming through, and is considerably lower than the other side of the circle, so I plan to put more...
-
Maybe you're thinking of a different drain than what I have. I tried unscrewing it with my hands, nothing doing. Then I tried with 2 wrenches, and all I created was a bunch of little metal shavings....
-
I have a tub that has enough of my wife's hair in the drain that it doesn't drain fast enough during a shower, and it doesn't hold water during my kids bath.
My primary question is, how the heck...
-
Just a follow-up, I turned the lights off, did some work upstairs for a half hour or so and went back down. The switch and metal plate are normal temp. Not sure if this is useful information or not!...
-
Hi. I recently wired up can lights in my basement. Each light is a 75 watt halogen bulb. There are 6 of them on the switch.
There is a 15 amp breaker with 14 ga wire. The switch is one of those...
-
Hi.
I'm installing recessed lights in my basements finishing job, and I bought a bunch of cans at home depot. 12 to start with, but I'm sure I'll need more. My question is about the spacing for...
-
OK, I am clicking on back. I think I understood about the p-trap solution. That shouldn't be a problem.
Regarding the placement and width of the tub, when I stated the drain needs to be 18" from...
-
I have 2 questions regarding my rough in for the tub in my unfinished basement. My first question regards the p-trap for the tub. This house was built in 2001. Is it common for the p-trap to be put...
|