Search:

My rheem heat pump model RJMA outside fan runs on defrost mode, however everything else seems to run fine

Hey Grady thanks for the response, the pump is very old could be original where you able to get pump number by the unit model ?

American Standard Oil furnace model ACD 603 pump stuck and won't turn. What is the equivalent for a Sundstrand 1298 100 3 that I have.

Samsung RB2155BB stops cooling after about 8 hours of working fine I have to un plug and replug to start cycle all over again I've already replaced mainboard

Now I reset the mainboard fridge runs and cycles for about eight hours or so then quits I have to unplug then replug to start cycle

I know the fridge has been satisfied everything is good however compressor doesn't shut off until it overheats I guess I remember it being very hot to the touch

Hey guys Samsung RB2155BB compressor still runs after fridge is satisfied, then shuts down and doesn't restart. Pull out plug and plug back in cycle starts again. Please assist thanks.

Hey my GE chest freezer model # CB15DNB stop freezing all I hear is a relay type sound about every ten minutes or when I plug unit in.

Hey guys 2005 chevy tahoe tire feels like it's going to flip over during sharp turns,I'm anot hereing any sounds just a flipping feeling

TxGreaseMonkey you did it again! After dropping it in sat.morning everything's sweet fires up after waiting a few minutes. However one thing puzzles me the check engine light reset itself. It does...

Will do buddy, will do!

Darn it heck just got it from auto-zone for $8 cheaper, thanks always lemon-lime!

Checked code and it said camshaft position sensor just as you said will be installing it Saturday morning with the confidence will keep you in the loop thank you partner!

OK cool the check engine light did come on I started it this morning OK, however this afternoon I heard a whining noise, like a something was spinning fast. Does this sound familiar?

2006 Nissan Altima S when hot say about a hour of driving after stopping, it won't start after sitting for about 15 minutes, however wait 1/2 hour or next day will start.

You are right ScottGem, I started needing a simple computer,however I have all these monitors laying around thought I'd use one! I have L-shaped desk and have plenty of room

Question I don't have the vga connection either, so I would have to buy one of those also to put on the desktop?

I haven't tried anything yet what do u suggest

I want to hook up two monitors but my EL1331G-01w emachine the vga isn't loaded on my sleek desktop

My fan blade is possibly bent I have a Revcor 70 19897 04 what does this equate to I could either get it from Grainger or CC son thanks for all you do!

Hey guys I have a rudd heat pump. Needed to change the motor . I had difficulty getting the fan blade off, so I took it to the local home improvement center to have the fan blade taken off with a...

Hey I have rudd heat pump and the fan motor won't turn it turns about 2 inches and stop if I need a capacitor what size my model # rjma-a048jk serial # 5592 f219812989

I have a Whirlpool Model # LSR6132EQ1 washing machine and the clothes mover is very loose however it still seems to wash clothes fine . What should I do next?

I noticed their was no hot air coming through my vents I checked the run capacitor and noticed the wires where burnt off one prong so I spliced the and reconnected. That worked fine for a week or so...

I want to change my run capacitor on heat pump the label fell off how do I figure out what size fits my heat pump. The current one has two[2] sets of prongs and is round is approximately 5-6" long

Hey guys , we rent out a house in North Carolina.The tenant abandon the property what do we do with their belongings?

Hey my house was built in the 1940's I have two built in fireplaces measuring about 2' wide and about 12" deep however they don't have dampers and the flames just get sucked up without providing any...

Wifey said it's the bottom stitch!

Wifey says bottom stitch is loose!

Bottom stitch is loose

Hey I have a Euro Pro X Model # 9120 sewing machine, the stitches won't stay tight even after turning the tensioner knob on top. We also sent it out for repair and maintenance,after a few dresses...

Yes! It's August in North Carolina however I don't want to wait until winter to start worrying about this. What procedures do you go through if the pilot lite goes out? Could it be as simple as that?:

Yes this job was done by a local professional company.They first got the furnace working however the tank was underground and possible filled with water.So in turn we put a tank above ground and ran...

Am. Standard Oil Burner just changed oil filter,nozzle.new tank and lines. Just had the unit serviced was running for a couple of days then shut off I bypassed the thermostat and it ran for the day...

What should I set the multimeter for testing the transformer and should I test the contacts or the wires going out

How do I check my transformer of my oil furnace unit working fine then just quit.I tried direct wire eliminating the t-stat however no results please assist

I'm a little confused about the wiring new motor has br,br/wh,bl,wh. I understand brns go to cap. Separate posts however where on the contactor does the white and black go on .Question is it possible...

Yes I installed a new 5 mfd with the new motor

New Condenser Fan Motor runs 5 minutes then quits,however compressor continues to run ,I turned off the t-stat demand. Fan seems warm to the touch,will start up after 30 minutes or so please advice

My unit is a Rudd model# UPGB-025JAZ, 208/230 volts year 1997 I believe I have a single pole contactor with a 24 volt coil.. PS thanks for hanging in their with me!

As stated before I have fan motor br,br/w,bl,and wh wires brns are on cap. And as advised black and white to top of contactor.However L3,T3,T1, are the open posts which wire goes on these...

I meant to say where on the contactor does the black and white wires go I already put the browns on the capacitor thanks for all your support

Where on the capacitor does the white and black wires go the capacitor is loaded

I replaced my old fan motor with a AOS fan motor with white,black,brown,brown w/white stripes where do they go? My Previous fan motor had yellow and brown wire-nut together,purple,orange and black...