Search:

How far behind the finished wall should I install the drop-eared elbow for the shower head? See the picture
Any problems if is 1.5" behind ?

Thanks

Hi,

I just changed a toilet bowl due to a pinhole leak - the water level drops overnight.
I 've learnt my lesson so I installed the second toilet bowl in my garage on a flat surface, slowly...

Hi Tom,

Thanks for your reply. Is about 1/2 " below the tile.

Regards from Frank

I am almost done tiling the bathroom floor and the old flange sits underneath the finished floor..
If I use a waxless ring like the one in the picture do I still need to add a 1/4" flange extender...

Hi,

I want to relocate the sink to the opposite wall. This is about 10' from the current location. Can I just extend the drain pipe under the floor from old to the new location ? I am not quite...

Hi Tom,

I replaced the picture in the previous post. With yellow line is how the old p trap was attached to the drain pipe using a 90 elbow.

With red is how I want to connect the new 2" p trap...

Hi,

Should the 2 pieces of the shower p trap be in the same plan ? In order to align the p trap with the 2" drain pipe I will need a 135 angle between them. I'd like if possible to avoid one of...

Thank you Tom !

Just to make sure I am on the same page with you:

1. cut at the base of 1 1/2". That will give me about 3/4" room to work with
2. clamp the remaining 3/4" of pipe to the left...

Hi,

I want to upgrade a bathtub drain from 1 1/2 to 2" because I am replacing it with a shower.
I dug a trench all the way to the 3" horizontal stack and found that I can cap the old 1 1/2 pipe...