Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: bandb

Search: Search took 0.00 seconds.

  1. Answers
    4
    Views
    433

    No it run a few minutes and shut down then the...

    No it run a few minutes and shut down then the fan kicked on a few times it just wouldn't heat
  2. Answers
    8
    Views
    1,029

    What kind of units do you all have

    What kind of units do you all have
  3. Answers
    4
    Views
    433

    So if there was much larger flames then it would...

    So if there was much larger flames then it would have been burning hotter which probably would have messed up the limit switch right?
  4. Question: Circuit board

    by bandb
    Answers
    5
    Views
    717

    Make sure your t stat is working properly it...

    Make sure your t stat is working properly it could be going bad sometimes calling for heat and sometimes not I've learned most the time it something simple hope this helps
  5. Question: Circuit board

    by bandb
    Answers
    5
    Views
    717

    Did it specify that it was the pressure switch

    Did it specify that it was the pressure switch
  6. Sticky: We thank you for all you all do

    We thank you for all you all do
  7. Answers
    8
    Views
    1,029

    Hey I'm not for certain about the laws where your...

    Hey I'm not for certain about the laws where your at but I think you have the right to withhold rent till it is fixed
  8. Answers
    8
    Views
    1,029

    Hey I'm not for certain about the laws where your...

    Hey I'm not for certain about the laws where your at but I think you have the right to withhold rent till it is fixed
  9. Answers
    4
    Views
    433

    Converting natural to lp

    Hey this is leslie can someone please tell me if you forget to convert a reem gas pack from natural to lp and start the unit will it damage any of the componets or will the safety features just shut...
  10. Answers
    8
    Views
    1,413

    Thanks for all your help. You know what it ended...

    Thanks for all your help. You know what it ended up being? t-stat.guess I should have been thinking more simple lol.
  11. Answers
    8
    Views
    1,413

    OK before reading yours I put uld board back on...

    OK before reading yours I put uld board back on inducer motor came on so your righ about the board is there any way to check pressure switch or jumper it
  12. Answers
    8
    Views
    1,413

    It was wired the same way it came off I done them...

    It was wired the same way it came off I done them one at a time if that pressure switch is bad would it cause it to have less operation after replacing the board then it had before the board was...
  13. Question: Heil unit again

    by bandb
    Answers
    0
    Views
    263

    Heil unit again

    We changed the gas valve and rollout switch neither one of these made a difference changed the control board and now the inducer motor won't even come on how likely is it that the pressure switch is...
  14. Answers
    8
    Views
    1,413

    Does not have led light we replaced the gas valve...

    Does not have led light we replaced the gas valve that was not it replaced rollout switch nope not that either replaced control board now nothing there were serveral burnt spots on the board could...
  15. Answers
    8
    Views
    1,413

    Heil unit won't ignite

    What is the most likely cause of this inducer motor comes on but unit won't ignite model #pgaa36d1k3
Results 1 to 15 of 15