Search:

furring strip are pieces of 1x2 wood that are use to install drywall that do not required insulation.. If you are going to put insulation on the walls you need to use 2x4s..

I have a 95 chevy monte carlo,when I turn the vehicle on, it idles very high. What do I do to fix this problem? The rpm needle goes as high as 3 it only drops when I shift the gears but when I shift...

My furnace runs for about an hour then shuts off before the thermostat is satisfied, however the combustion fan remains on, I can not shut it off from the thermostat I have to shut it off from the...

Actually I have the same problem, I have a tappan furnace high efficiency..

It is only blowing cold air not hot, I was told that my limit switch is bad however I already replaced it and it is...

I have an exterior electrical outlet that is not working, (gfci), however I was trouble shooting the outlet and I came across that two outlets in that circuit are not working.. here is the scenario;...

The old radiator was leaking.. I did bleed the radiator when I installed it.. also the sensor is connected the to the electrical plug but there is a u shape ring that I did not put back on the...

Thank you captain Rich, now what is the replacement radiator? And what do you mean by the connector being reattached? What connector?

I recently installed a radiator on a 1995 chevy monte carlo 6 cylinder 3.1 engine, however I am not sure if I installed it correctly, my low coolant sensor light is always on, but the coolant lever...

I recently purchase a replacement switch for an electric sewer auger model k-38 I wired it exactly the same way the other one was, however upon connecting the machine to the power source the machine...

I recently purchase a replacement switch for an electric sewer auger model k-38 I wired it exactly the same way the other one was, however upon connecting the machine to the power source the machine...

I believe that I was misunderstood, the gas company needs to inspect the gas meter but the meter is nowhere to be found it is not visible their records show that it is in front of the property...

I have been living in this property for a few months, the utility company came over to read the gas meter and to our surprise it was nowhere to be found, I just realized that the gas meter is inside...

I really do not think that I need a 200amp service like I said before I have had the same systeem for the past 7 years or so and up to now I have never had any of those problems.

So you may be...

Well, I am going to check my compressor motor I believe that may be the problem. Is that hard to change?

No I do not have any other units I only have 1 30 amp breaker the rest are all 20's and 15's

I have a 100 amp service approximately 10 breakers 15 amp and 20amp with one of them being a 30amp that is hooked up to an ac unit. Well a few days ago I arrived home to realize that I had no power...

Ok, well the reason that the low coolant light was illuninated was because the replaced radiator was defective, I replaced it with another one I also replaced the bleeder pipe so now I could bleed...

The bleeder on this vehicle is broken, is there any other way to bleed the radiator?

[QUOTE=this8384]The coolant level sensor in the overflow tank is bad. Go to GM; the part itself shouldn't be more than $20-30.[/QUOT

Is this common to happen, do the sensors normally go bad when...

I recentrly replaces a radiator on my 1995 chevy motecarlo 3.1 engine the issue that I am having is that the low coolant light on the dash board comes on and off periodically I check the level of the...

Mike, I suggest that you should contact a qualify person that works with electricity that would be your best way to go.

That won't happen, the french laws are not like the us laws in order for you to have french citizenship you have to be like 3rd generation french citizen you can not just be born there and that...

Mike, I think that your problem is not similar to mine, yours seems to be that you have an over load on your circuit I believe that you having a mobile home do not have a as many branch circuits as a...

[QUOTE=hkstroud]I think it's time to call the power company back and insist that the meter be pulled and the voltage and amphereage form the pole be checked. Changing th panel will not correct the...

OK, the type of furnce that I am operating is a gas furnace and you are correct it is a small motor that is running so the voltage drop is not due to the furnace the voltage drop also happens around...

Well thank you for your resposnse, I really appreciate your input I actually had two electricians stopped by so far but the issue that I am facing is that no one has opened up the cover and checked...

Ok, I purchased a property a few months ago I had an inspector go over it to see if I needed any repairs, there were a few things that were pointed out and they were repaired.

A month after...