Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: pokefan7790

Search: Search took 0.00 seconds.

  1. Honda 3011 starts but dies when chifted into gear or if pto engaged

    Honda 3011 starts but dies when shifted into gear or if pto engaged
  2. If it agitates, the motor is probably OK. Most...

    If it agitates, the motor is probably OK. Most likely the lid switch is defective.
  3. You don't. Everything comes out through the...

    You don't. Everything comes out through the front. Use a putty knife between the top and front panel to release the two clips that hold the top down and lift it up and tilt it back. From the inside...
  4. Answers
    1
    Views
    480

    Replace the water inlet valve assy.

    Replace the water inlet valve assy.
  5. Answers
    4
    Views
    639

    You didn't say what brand. Some dryers have a...

    You didn't say what brand. Some dryers have a thermal fuse that will not allow the dryer to come on if it is blown.
  6. Answers
    1
    Views
    360

    Top load washer:it's probably the lid switch...

    Top load washer:it's probably the lid switch
    Front load: it:s probably the pump inlet clogged or the pump is bad
  7. Answers
    2
    Views
    879

    Sounds like the lid switch is not closing

    Sounds like the lid switch is not closing
  8. Answers
    3
    Views
    436

    The switch is located in the control panel. It is...

    The switch is located in the control panel. It is connected to the knob you use to select load size. There should be only one hose connecting the pressure sensor on the switch to the side of the tub...
  9. Answers
    3
    Views
    436

    The water level switch is a pressure operated...

    The water level switch is a pressure operated switch. It has a tube (hose) that connects the switch to the bottom of the washer tub. If it comes loose or gets a hole in it it will cause the washer to...
  10. If this machine has a separate pump from the...

    If this machine has a separate pump from the drive motor, it could be the pump. Pump inlet clogged or drain hose clogged.
  11. Could be the lid switch.

    Could be the lid switch.
  12. Answers
    1
    Views
    592

    Probably the drum belt is off or broken.

    Probably the drum belt is off or broken.
  13. Answers
    1
    Views
    641

    Your house drain is slow. This allows water to...

    Your house drain is slow. This allows water to back up and siphon the water from the tub. Create an air break where the hose enters the drain, and make sure the house drain is clear and flowing. Make...
  14. You have to partially remove the rubber boot...

    You have to partially remove the rubber boot between the washer front and the tub, to access the door latch. There should be a spring holding a wire band tight around the outer edge of the boot...
  15. Is there frost build-up in the lower back part of...

    Is there frost build-up in the lower back part of the freezer secttion? If so, the unit is not defrosting properly, either because the timer is not telling it to, or the defrost components are...
  16. Answers
    1
    Views
    416

    The coating is coming off the ice mold. You need...

    The coating is coming off the ice mold. You need to replace your icemaker, Or you could just replace the mold. A little cheaper but more work and skill required.
  17. Check to see if the drain pump is pumping a full...

    Check to see if the drain pump is pumping a full flow of water. Sometimes the inlet gets clogged with debris.
  18. Answers
    2
    Views
    471

    Simply put. The motor runs on 120 volt power and...

    Simply put. The motor runs on 120 volt power and the heating element operates on 240 volts.
  19. Replace the motor. About a $40 fix

    Replace the motor. About a $40 fix
  20. Answers
    6
    Views
    654

    If you cleaned the coils and its still running...

    If you cleaned the coils and its still running hot, make sure the little fan in the back by the coils you cleaned is running.
  21. Answers
    4
    Views
    888

    The switch that the know connects to. Its called...

    The switch that the know connects to. Its called and infinite switch.
  22. Answers
    4
    Views
    1,083

    Front load or top load?

    Front load or top load?
  23. Most of the components for this dryer are...

    Most of the components for this dryer are accessed from the front. Use a putty knife between the top of the bottom panel and door frame to release the spring clips that hold the bottom panel in place.
  24. Answers
    1
    Views
    614

    Your house drain is draining slow or the...

    Your house drain is draining slow or the discharge tube is pushed down too far into the trap on the drain. The drain is siphoning the water out of the machine.
  25. From the illustration it looks as though it is...

    From the illustration it looks as though it is behind the toe-plate behind a small cover on the right-hand side.
  26. Most likely the lid switch is broken.

    Most likely the lid switch is broken.
  27. Answers
    3
    Views
    421

    Some of the Whirlpoolo built Kenmores have a...

    Some of the Whirlpoolo built Kenmores have a thermal fuse on the back.
  28. Answers
    2
    Views
    924

    Sounds like the cold water side of your inlet...

    Sounds like the cold water side of your inlet valve is clogged or not opening properly. There should be a screen in the inlet of the valve that may be cleaned. Otherwise, the valve will have to be...
  29. Answers
    2
    Views
    541

    If the motor is not running or trying to run when...

    If the motor is not running or trying to run when you turn the dial to "spin" it is probably the lid switch or actuator
  30. Answers
    1
    Views
    345

    Sounds like the lid switch

    Sounds like the lid switch
  31. If the motor is not running or trying to run in...

    If the motor is not running or trying to run in the spin cycle it's probably the lid switch. If the motor is trying to run, (humming, buzzing) it could be something lodged in the pump.
    I would try...
  32. Answers
    1
    Views
    375

    How about the door switch?

    How about the door switch?
  33. You need a new timer. This is a whirlpool design...

    You need a new timer. This is a whirlpool design and it has what is called a neutral pump-out where the motor runs and the pump pumps the water out but the tub doesn't spin. The timer is supposed to...
  34. Answers
    1
    Views
    1,079

    The ice door is the problem it should be solenoid...

    The ice door is the problem it should be solenoid opened and spring closed. Either the spring is broken or the solenoid is rusted. This is a common problem with certain GE side-by-sides..
  35. Answers
    2
    Views
    620

    If there is a lot of frost on the back wall of...

    If there is a lot of frost on the back wall of the freezer, (inside) it's not defrosting. The typical cause for this is the defrost heater. ( behind the back panel in the freezer at the bottom)...
  36. There is a problem in the defrost system. If this...

    There is a problem in the defrost system. If this is a GE built kenmore it is probably the defrost heater. Need the model number to tell the difference.
  37. Answers
    3
    Views
    5,598

    It sounds like your drain is syphoning the water ...

    It sounds like your drain is syphoning the water out as it tries to fill. This is caused by a slow drain or an improperly installed drain hose. Make sure the drain hose is not pushed in to the drain...
  38. Does it spin? Does it pump the water out?

    Does it spin? Does it pump the water out?
  39. If this is a frigidaire built kenmore, you may...

    If this is a frigidaire built kenmore, you may have to remove the drum to get to the element.
  40. Answers
    2
    Views
    481

    If its filling with the machine off you need new...

    If its filling with the machine off you need new inlet valves. If it continues to fill and runs over only when it's trying to wash, it's either the fill level (pressure) switch or possibly a hole or...
  41. Answers
    2
    Views
    1,020

    Put some water in and see if it will agitate. If...

    Put some water in and see if it will agitate.
    If it won't agitate, turn it to spin and see if it will pump the water out. If it won't agitate or spin but the motor runs and pumps the water out, the...
  42. Answers
    13
    Views
    3,087

    If the evaporator behind the panel inside the...

    If the evaporator behind the panel inside the back of the freezer section is frosting top to bottom, the compressor and refr. Charge are usually OK. It sound as though you have a defrost problem and...
  43. Answers
    1
    Views
    504

    If this is a top freezer model, the water can be...

    If this is a top freezer model, the water can be coming from one of two things.
    1. Leaking refrig. Door gasket
    2. the freezer drain is stopped up and water from defrost is overflowing into the...
  44. Answers
    4
    Views
    6,803

    It could be the water level switch. (pressure...

    It could be the water level switch. (pressure swith inside the console with the little hose connected to it).
  45. Answers
    5
    Views
    728

    Need more info. Complete model number would be...

    Need more info. Complete model number would be helpful
  46. Answers
    1
    Views
    401

    Timing belt replacement

    Where can I find directions for replacing timing belt on a Mitsubushi Outlander, 2003 model. 4 cyl
  47. The dryer will run if one of the fuses is blown...

    The dryer will run if one of the fuses is blown or if one leg of the circuit breaker is tripped.
    The fuses mentioned in the owners/operators manual are the ones for the residence not inside the...
  48. ...

    ...
  49. Answers
    2
    Views
    655

    If you can hear the motor runnilng it is the...

    If you can hear the motor runnilng it is the motor drive coupling.
  50. Answers
    4
    Views
    1,056

    You should be able to purchase the agitator dogs...

    You should be able to purchase the agitator dogs at any store that sells whirlpool or sears appliance parts.

    The job is not to difficult. It requires removing and separating the agitator. The...
Results 1 to 50 of 63