Search:
Type: Posts; User: Narataru
Search:
Search took 0.00 seconds.
-
I have this panel in my house and the main 2 switches say 100, like in the illustration. Do I have 100 amp service or 200 amp service panel? Thanks.
-
Thanks you for your answers. I still have the same question, can I replace a 15amp breaker with a 20amp breaker changing all the circuit to #12 wire or would the circuit be overload?
-
Can I do the same with the Dishwasher. I only have 15amp breakers in the Panel and I want to install a dishwasher. Can I replace the breaker for a 20amp if I replace the entire wire to #12, so the...
-
When I say 3 wire, I mean black, red, and white (and ground).
And if I replace the entire circuit with a #12 wire, can I replace the 15amp breaker with a 20amp breaker?
Thanks...
-
I want to install GFCI receptacles in my kitchen counter-top. Can I use 3 wire cable or it won't work? Thanks
-
I'm rewiring my entire house and I have a 125amp panel. My house is small, about 800sqft but I'm finishing my basement then the area will be 1,600sqft. I don't have any 20amp breakers in the panel...
-
I want to thank all for your answers, they show very clear your interest in helping me the most accurately possibly. I understand that I'm a bit frustrated when I don't understand a topic because I...
-
I agree, Stanfortyman, I'm clueless how this site works, probably after 2,000 posts I'll understand why this post was deleted yesterday and is back again today.
You as an electrician didn't help at...
-
Because I'm still looking for answers. I didn't agree with yours, it wasn't enough for me. I might be lucky and find an electrician in this site to answer my question.
-
The electrical service panel in my house is physically full. It is a 125amp panel.
I'd like to know if additional amperage can be added. How do I count the capacity of the panel?
...
-
I bought a Refrigerator about 4 months ago. It is a General Electric. I never plug it in before, not even tested in the store before I bought it. Yesterday I plug it and it didn't work. I don't know...
-
If I want to know the measure of a room in a blueprint, how do I measure. For example, the blueprint says 10'4".
The width of that room measurement is from stud to stud or finished drywall to...
-
I'm installing a downspout around my garage. I don't know if I need an elbow or not, because the gutter around the garage is very close to the wall.
Thank you.
-
Can I cut the joists in the Attic to run the pipe from the toilet to the stack, without getting structural problems with the roof?
-
This is my question. What's the max. length for a Vent Pipe? Thanks
-
Hello,
I'm going to install a 2nd vent stack, but I don't know how close they can be one to another, by code, and to the chimney. Thanks.
-
Hello,
I want to install a bathroom in the Attic.
Can I stack vent this bathroom too?
Thanks.
-
Hello Mark,
Thank you very much for your answer, that helps me a lot. I read books and search in the Internet, but your answers are the fastest way and very accurate. Thank you. :)
-
Hello,
Can I use an Automatic Vent device to vent a washer machine drain, or use a loop vent? Thanks. Nara
-
Then, If I connect 3/4" pipe after a 1/2" pipe feeding, nothing is going to happen? Will I have same volume and pressure of water as I had with a 1/2" pipe? Then is better just pipe the house with...
-
Hello,
Thanks for your answer, but I still don't understand if I can connect after 1/2" pipe another pipe that is 3/4". So, bigger pipe connected to smaller feeding pipe. Thanks again. :confused:
-
Hello,
Can I connect 1/2" pipe to 3/4" pipe and will I have a good supply of water? Thanks :confused:
-
Can I connect Cast Iron to PVC like this, and what kind of joints do I need? Thanks again
-
Hello,
I was wondering, how to connect the section where the pipe connects to the main stack? That stack is Cast Iron Pipe. Can I add CPVC in that section? Should I drill a hole in the stack?
Thanks
-
Thanks a lot for your help. I'll start my project and hopefully get it ready this weekend. :D
-
This is how the main bathroom is now, I don't know if it's vented or not right now. Thanks.
-
How to vent this bathroom if the main stack vent in the house is lower than the bathroom level. Do I need a 2nd vent stack that goes through the roof? This is the plans.
|