Search:

The old classic Brooklyn accent pronounced oil as "earl"
In Boston the "R" is unmistakable as paRk the caR

Can anyone tell me where to find the installation procedure for brushes in a Skil 5150 circular saw

1989 GMC K1500 5.7 liter TBI engine 4L60C trans

Can anyone confirm if there is a sensor to shut power to the fuel pump if oil pressure is lost. A friend om mine is positive it exists but can't...

Thanks for the advice.

How do you refurbish a car battery. I see adds on Ebay to buy the info to do this.

On level highways you should be OK. Don't use overdrive if you are on hills. I learned the hard way. The 4l60c in 89 K1500 died a horrible death pulling my car hauler on a warm day.

Thanks to all. A couple of taps and it idles again.

Engine will start and stop immediately and continue to restart. The only way to go is to hold the gas pedal down a little and drop it in gear. Where is the sensor that controls the idle?

On the back of the remote should be an eight digit part number and an 800 phone number for support. It should also have an FCC ID number. You can get help by using Google or calling the toll free...

I have the answer provided by a local plumber. Thanks

I have what appears to be an air valve in the line to the pressure relief valve on top of my oil fired boiler of a hot water heating system. Is this possible? What happens if I eliminate it?

Code P2285, Injector Pressure Sensor Circuit Low

The Injector Pressure Sensor is behind the turbo, it has been known to get an internal leak of oil and go bad.you need an 1 1/16 crows foot wrench...

I was able to download the manual from a site I found. Hope fully I will be able to get this done. If I do get stuck, I will be talking to my new best friend. Thanks for your input!

I don't know if I can get to programming. System is hard wired.
Old sensor is 2112/24T replacement is 4wt-b. When the sensor is changed my next job is to replace the keypads

I need to replace one smoke sensor and want to be clear on procedure. I also plan to replace my two key pads.

I would like to get this manual so I can maintain my system. I am no longer monitored.

OBD2 reader says CEL is result of knock sensor. Where is it?

Let the engine idle in the driveway and look for the leak it will probably drip to the ground. Don't smoke while looking!

If you plan to install it yourself, take it out now and measure it.

Check out POR15 those paints and coatings stick

Many algae are huge single cell organisms. THe cell wall is the boundary and the genes are the limiting factor

Unsanded and yes wear gloves.

I did my basement with a spray gun and it looks much better than what was there.

Remove the damaged grout and replace it with new. A small area like this usually means there is no problem under the tile

The first important step is selecting the correct adhesive. It must be stated by the manufacturer for this job.
The second important step is to allow the adhesive to cure a full 24 hours before...

It appears the concrete was poured with a wet mix. That led to increased shrinking and the crack in the control joint. I recommend you take a hammer and chisel to take off the irregular edges. Then...

Where do you live? What is a mot?

I think you have yellow jackets not bumble bees. Bumble bees die after stinging. Yellow jackets and other hornets and wasps are predators and can sting repeatedly. Your easiest solution is to mark...

Google Northvale Auto Parts Small independent part store with lots of info and old parts available

The silver maple is famous for falling over in high wind because it has a poor root anchor. Cutting those roots condemned your tree to almost certain failure. Get it topped off or completely...

I own one of these trucks and have had the same problem. Get the cheapest replacement light fixture that you can and install it in five minutes. Your problem will be solved

Drain the radiator. Disconnect the hoses and trans cooler lines. Remove radiator. Install new one in reverse order.

Those big sound systems require larger output alternator and battery.

It should be gear oil.

If the posts are physically sound( no rot), I recommend straightening them with braces on the side they leaning to and tamping the earth around them as firmly as you can. In my experience says this...

Loosening up equals less engine drag and permits more coasting and better mileage. It also means more brake wear. You said the same thing in your original post.
PS: I believe asbestos was...

In the olden days AT cars would decelerate quite well by lifting your foot off the gas. Later model cars are the victim the federal bureaucracy. They ordered all automatic transmissions to be...

I don't know about walking on these tile but I can tell you not to waste your time with spike strips for birds. I spent years trying to stop pigeons and please believe me given enough time, the bird...

My local codes require an air space behind the wonderboard

If you live in very cold climate, it is sometimes a good idea to forget gutters because of ice dams.

Go to a Honda dealer with your registration and license. They can make you a key for less than you paid for that switch. Return the switch for a refund.

With few exceptions felons can't become peace officers. They can't own firearms and it many places they can't vote.

My 2000 Grand Cherokee was acting the same way. It was the cam position sensor. 40K later it is still OK

Do a pressure test. If it looks like head gaket. Try Barsleak head gasket and block sealer and FOLLOW DIRECTIONS exactly. I used it in 350 small block with 671 blower over three years ago and it...

94 Grand Marquis with digital dash. Speedometer shows various speeds with car in park and engine running. Odometer and trip counters mileage advances while you sit and watch in a motionless car. ...

Most cars today require the brake pedal to be pressed when shifting from park. With a dead battery the interlock can't operate. Charge the battery first.

It sounds like your clutch master cylinder, slave cylinder or lines has a problem.

I have called Rock Auto several times. They have great people on the phones and can probably tell the manufacturer on their toll free line.

It is definitely not the computer. It is in the steering column/lock cylinder. A local locksmith or a car mechanic is your best source for help.

You can make your own mortar if you wish. Google Type O mortar and get multiple sites with recipe. But why would want to use this weaker mortar?