Search:
Type: Posts; User: runner_122
Search:
Search took 0.01 seconds.
-
Hi guys,
Wondering if you can help me time with this engine. The points and coil caseing was removed by owner to change the seal on the crank. Now it appears like the timing is off. New points. The...
-
ballengerb1,
Thanks for the response, water has been drained below the light,and have got around to removing the inside framing and gasket everything is fine there. Like you mentioned the wall...
-
:) I have a 15x30 above ground pool. With the terrible winter we have just experienced, the pool light is now leaking from what I can see out the exterior of the large plastic nut that retains the...
-
Hey guys, try "woods.com" model #49112 under timers- canadian listing, good luck
-
lgryner, try "woods.com" look under "timers" instruction sheet for your photo (can. Model is N1506)
-
hi hellinga, to set your program on/off. Have your present time set first,
then press "right" arrow under program,
now "set". Days will flash by pressing either arrow day/days will change if you...
-
Thanks again TerryB, I will be attacking these walls tomorrow morning complete with vapor barrier this time. Just installed an air exchanger and getting rid of the portable dehumidifier, so hopefully...
-
As per a previous thread I am in process of insulating my basement. I have taken the advice of TerryB with his great link to insulating. I have run into only a little problem I hope. I installed...
-
Thanks TerryB,
You hit the nail on the head with the link you advised. I have gone to this website but never found that exact page, it's rite there in black and white. Thanks again
-
:confused: finishing basement and I am curious as to how deep should I put the insulation in the joists. I am using #15 roofing paper 3/4's of the way up the cement wall with 2x4 studs and r-12...
|