Search:
Type: Posts; User: popatim
Search:
Search took 0.00 seconds.
-
The pump may have sheared a coupling, usually plastic and rubber and fairly weasy to replace, if it uses one.
If it doesn't then your in for a new pump and motor assembly.
-
The only tiime my dishwasher smells is on chili night...
All kidding aside, have you tried running a cup of bleach through it (empty of course) followed by a few empty rinse cycles? Also check...
-
There are two screws on the top console, remove them both and lift and fold it back. Near the center there is a wiring harness connector for the lid sensor, disconnect that. There are two odd metal...
-
Poor ventilation could cause this. Disconnect the vent line and clean it out. Dry a load with it disconnected and see if still too hot. If not then reconnect the vent and check the airflow on the...
-
It sounds like it is spinning but out of balance which will eventually shut off the spin cycle. You;ll need to balance the load and watch the spin cycle to see if its not spinning fast or not pumping...
-
The washer is a Kenmore ultra fabric care. I'll post the model # later if its needed.
This past Sunday the washer stopped agitating, spinning, and draining.
Could the timer cause all this at...
|