Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: wheatnbarley24

Search: Search took 0.00 seconds.

  1. Try isolating the problem by disconnecting either...

    Try isolating the problem by disconnecting either the contactor or reversing valve solenoid one at a time to find out which one is actually blowing the fuse
  2. Answers
    1
    Views
    449

    Sounds like you going to have to put one wire to...

    Sounds like you going to have to put one wire to rc rh and w1 nt sure if that stat willl owkr without a common wire. Some do some don't
  3. Answers
    2
    Views
    438

    Where exactly is this reset button?

    Where exactly is this reset button?
  4. Answers
    1
    Views
    553

    Could be a short in the thermostst wire from the...

    Could be a short in the thermostst wire from the t-stat to the heater, or a control board acting up
  5. Answers
    2
    Views
    2,215

    When the unducer fan motor turns on do your hear...

    When the unducer fan motor turns on do your hear the pressure switch click? The pressure switch will be connected to the inducer motor by a rubber hose
  6. You unit has probably frozen up due to either...

    You unit has probably frozen up due to either being low on freon ,dirty filter, or coil shut unit off for a couplr of hour with just the fan on the on position
  7. If it was a bad compressor the fan would come on...

    If it was a bad compressor the fan would come on on its own and the compressor wouldn't, or the unit would throw the breaker immediately, if you don't see any burnt wires its is probably the...
  8. Answers
    3
    Views
    995

    That could be any number of problems, is the...

    That could be any number of problems, is the outside unit running during these "lukewarm" spells? Is the fan on the outside unit running but not the compressor?
  9. Either the blue or the black wire has to be used...

    Either the blue or the black wire has to be used to energize the fan, and one wire will probably be your common. You should check at the heating unit to see which wire goes where.
  10. Answers
    3
    Views
    1,378

    Is the furnace electric heat or gas heat ?

    Is the furnace electric heat or gas heat ?
  11. Answers
    2
    Views
    1,126

    A manual reset button should be somewhere on the...

    A manual reset button should be somewhere on the back of the stat face
  12. Check and see if the little rubber hose fron the...

    Check and see if the little rubber hose fron the combustion motor to the pressure switch is clear of debris. The unit will not go to the second stage of operation if this switch doesn't close
  13. Answers
    1
    Views
    913

    It could be a relay, a capacitor, or worse case...

    It could be a relay, a capacitor, or worse case senario the blower motor itself
  14. Answers
    5
    Views
    4,162

    Grandaire equipment is made by nordyne which...

    Grandaire equipment is made by nordyne which makes a number of different units frigidare being on of them, if I were you id go with the trane 14 seer if it is within your price range, nordyne is much...
  15. Answers
    1
    Views
    1,213

    Any where from 200 to 300 dollars

    Any where from 200 to 300 dollars
  16. Answers
    7
    Views
    807

    I would change the fan limit before I go messing...

    I would change the fan limit before I go messing with gas pressure
  17. Answers
    22
    Views
    8,528

    The humidistat would be wired in with a relay...

    The humidistat would be wired in with a relay which would override the thermostat making the unit run at a lower fan speed until desired humidity setting is reacher(may over shoot set point by a...
  18. Answers
    3
    Views
    428

    Most 90% furnaces should be set up to run as a...

    Most 90% furnaces should be set up to run as a two stage heat furnace
  19. Answers
    20
    Views
    5,868

    Like esquire said, returning it for one with...

    Like esquire said, returning it for one with batteries is the easiest way for an inexpierienced person to do
  20. Answers
    22
    Views
    8,528

    I think a simple and cheap humidistat which would...

    I think a simple and cheap humidistat which would be mounted in your return air is the best solution to your problem
  21. Answers
    22
    Views
    8,528

    The units are sized properly for this area, you...

    The units are sized properly for this area, you also have to take into account the ceilings heights, if they are taller than the average 8 feet ceiling you are cooling that much more cubic feet
  22. Question: Trane xl90

    by wheatnbarley24
    Answers
    1
    Views
    969

    Their should be acode legend on the inside of...

    Their should be acode legend on the inside of one of the acces panels of the furnace
  23. Answers
    1
    Views
    851

    More than likely a fan relay is stuck

    More than likely a fan relay is stuck
  24. Answers
    2
    Views
    617

    Either polarity like corydec said or poor...

    Either polarity like corydec said or poor grounding
  25. Answers
    3
    Views
    786

    Sometimes you have to undo the gas line and purge...

    Sometimes you have to undo the gas line and purge the air out of the lines manually, the unit will only attempt to start itself three time before have to be reset
  26. Is the fan on the condenser working? If so it...

    Is the fan on the condenser working? If so it could be a number of things. Compressor overheated to due beinbg low on freon, burnt terminal on compressor, compressor locked up and needs hard start...
  27. Answers
    3
    Views
    1,612

    You can change your outside unit to a heat pump...

    You can change your outside unit to a heat pump unit
  28. Answers
    2
    Views
    1,134

    If you have horizontal cased coil there should be...

    If you have horizontal cased coil there should be a baffle behind the coil to stop water from blowing into the plenum. The plate may have fallen down
  29. Answers
    2
    Views
    3,276

    Did you have a problem with a leak before the new...

    Did you have a problem with a leak before the new unit was installed?
  30. Answers
    4
    Views
    1,647

    Check the emergency pan up in the attic, if the...

    Check the emergency pan up in the attic, if the drain clogs up the pan will fill up with water and trip a float switch shutting everything down
  31. Answers
    2
    Views
    750

    You probably have a short in your wire going to...

    You probably have a short in your wire going to your outside unit
  32. Answers
    10
    Views
    11,120

    Your fan outside is running but the compressor...

    Your fan outside is running but the compressor is probably not
    There or numerous reason the compressor won't come on
  33. Answers
    1
    Views
    2,796

    If you use a quality pleated type filter and...

    If you use a quality pleated type filter and change it reglarly you shouldn't have to clean you coils at all
  34. Answers
    3
    Views
    2,234

    I jumped out the low pressure switch and I still...

    I jumped out the low pressure switch and I still don't get 12 volts to the clutch
  35. Answers
    3
    Views
    2,234

    Ford ranger A/C problem

    I recently purchased a 93 ford ranger the clutch for the air conditionaer won't engage. The low pressure switch checks out good the fuses are good and the relay seems to be working but I am not...
  36. Answers
    6
    Views
    2,712

    The best thing you could do is buy a heated...

    The best thing you could do is buy a heated matress cover. Trust me... I've been thetre before and you won't need an once of heat with one of these


    About 50 to 70 bucks
  37. Answers
    7
    Views
    11,691

    You might want to make sure your filter and...

    You might want to make sure your filter and cooling coils are clean also your exchangers and flu pipe. Lack of air flow is the main cause of a limit tripping
  38. Answers
    6
    Views
    6,695

    He means a gas fired packaged unit

    He means a gas fired packaged unit
  39. Answers
    5
    Views
    27,634

    The unit could possibly going into the defrost...

    The unit could possibly going into the defrost cycle which usually happens on the coldest days. When a heat pump goes into defrost cycle the unit automatically switches back into the cooling mode and...
  40. Answers
    2
    Views
    1,523

    I've only seen this switch on trailer units and...

    I've only seen this switch on trailer units and like labman said all it does is open a damper to the outside air
  41. I've seen some house before where there wasn't...

    I've seen some house before where there wasn't any space for duct, where they uses foam duct board and lined the joist and the upper floor and closed in the bottom. So that you won't have any leaks...
  42. Answers
    2
    Views
    1,257

    I believe that its just reminder to check your...

    I believe that its just reminder to check your filter
  43. Answers
    6
    Views
    7,658

    The limit switch could be open for something as...

    The limit switch could be open for something as simple as a dirty filter or cooling coil, or a blickage in the flu pipe
  44. Answers
    3
    Views
    1,777

    Is it a heat pump?

    Is it a heat pump?
  45. Answers
    8
    Views
    21,667

    Normally if there is a fuse on a board it is for...

    Normally if there is a fuse on a board it is for the 24v transformer. Since your are getting 24v at g and c the fuse is good. I am more than sure that you need to replace the board.
  46. Answers
    8
    Views
    21,667

    If you have voltage across G and C on the furnace...

    If you have voltage across G and C on the furnace and aren't getting any power to the motor the relay on the control board is bad. Unforunatly you can't replace just the relay. The whole board has to...
  47. Answers
    8
    Views
    4,244

    Also with a Heat Pump your coil in the airhandler...

    Also with a Heat Pump your coil in the airhandler must be clean. If not the compressor outside could be overheating
  48. Answers
    4
    Views
    1,348

    If it is the quick connect type I have this...

    If it is the quick connect type I have this problem with them all the time. I just quit installing them all together
  49. Answers
    3
    Views
    690

    You actually have to be epa certified to purchase...

    You actually have to be epa certified to purchase freon, but a local supply house might find the license good enough
  50. Answers
    6
    Views
    4,099

    I recently refinished my cabinets. I founf a...

    I recently refinished my cabinets. I founf a paint and varnish remover made by Citri Strip. It has no harsh fumes, easy to app;y and does a pretty goood job.it took at least four coats of...
Results 1 to 50 of 63