Search:

Not sure what makes all the noise the motor or the fan. It's not a mechanical failure just noisier than I would like it to be. I thought they might have an upgrade to a quiter unit.

I have a Lenox Merit series (G40H-60C-110-03). The fan is loud and I wondered if they make a quiter unit.

Thanks
Lance

Do I just dab some flux around the hole and add some solder?

I have a 3/4" pex solder/barb fitting that I sweated in a gate valve. I missed a small spot and it leaks. I have tried to reheat the joint and add some solder but I can't get the joint hot enough...

I need to get my shower valves roughed in before the sheet rock guys show up. But I haven't selected tile yet so I don't know what my finished wall depth will be. Is there a safe guess? How do...

I have this urinal on the way and I'm trying to rough it in. I'm not sure where the flange needs to be mounted. I will have half inch sheet rock and tile on the wall. There's also the rubber...

Why didn't I think of that?





No real good answer I just wanted one.

Hello

Thanks for all the help with the shower rough in. I have a few more plumibing questions though. I'm roughing in my urinal and wanted to know if it needs a pee trap? Also is it OK to have...

3 foot seems to deep to me but it depends on the whole lay out of the kitchen. How thick is the granite and how well is it supported? It may not be strong enough to hold the sink filled with water...

Thanks for all the help getting my shower drain in. Before I pour my pan I was hoping to find a bench like the one pictured. I like how its open below the bench but can't find any information on...

I got them installed. Thanks again. I have another question about the shower drain. I'm going to do a custom poured shower pan and don't know how high to put the drain. Do I go flush with the...

That sounds good. I'm playing with the flexible couplings and can't get them to fold back on themselves. There to thick. I have American Valve brand. Am I missing something here?

Thanks
Lance

I found the pipe. If was below the paint mark. I wish I would have taken you up on your offer for tips on using a elec. Hammer. It didn't go easy. I would love any tips in case I need to use one...

Bump

I called the plumbing company that did work for the builder at that time. They told me to look for a blue or orange spray mark on the wall. I did find a blue mark so hopefully it's down there. On...

I don't know of any clean outs out side the home (could it be buried)and the other clean outs I referenced are at the bottom of stacks. The only other drain I know of is in the floor by the furnace...

I have two 3in clean outs and two 2in. The reason I believe the main sewer comes in the home at that location is because of a conversation I had with the builder warranty rep. My side walk settled...

I don't want to put my shower where the rough in is at. Where I do want it I believe the main sewer line coming from the street is in the vicinity. Is there a tool that would locate this pipe? ...