Search:
Type: Posts; User: lemonlime
Search:
Search took 0.00 seconds.
-
My rheem heat pump model RJMA outside fan runs on defrost mode, however everything else seems to run fine
-
Hey Grady thanks for the response, the pump is very old could be original where you able to get pump number by the unit model ?
-
American Standard Oil furnace model ACD 603 pump stuck and won't turn. What is the equivalent for a Sundstrand 1298 100 3 that I have.
-
Samsung RB2155BB stops cooling after about 8 hours of working fine I have to un plug and replug to start cycle all over again I've already replaced mainboard
-
Now I reset the mainboard fridge runs and cycles for about eight hours or so then quits I have to unplug then replug to start cycle
-
I know the fridge has been satisfied everything is good however compressor doesn't shut off until it overheats I guess I remember it being very hot to the touch
-
Hey guys Samsung RB2155BB compressor still runs after fridge is satisfied, then shuts down and doesn't restart. Pull out plug and plug back in cycle starts again. Please assist thanks.
-
Hey my GE chest freezer model # CB15DNB stop freezing all I hear is a relay type sound about every ten minutes or when I plug unit in.
-
Hey guys 2005 chevy tahoe tire feels like it's going to flip over during sharp turns,I'm anot hereing any sounds just a flipping feeling
-
TxGreaseMonkey you did it again! After dropping it in sat.morning everything's sweet fires up after waiting a few minutes. However one thing puzzles me the check engine light reset itself. It does...
-
-
Darn it heck just got it from auto-zone for $8 cheaper, thanks always lemon-lime!
-
Checked code and it said camshaft position sensor just as you said will be installing it Saturday morning with the confidence will keep you in the loop thank you partner!
-
OK cool the check engine light did come on I started it this morning OK, however this afternoon I heard a whining noise, like a something was spinning fast. Does this sound familiar?
-
2006 Nissan Altima S when hot say about a hour of driving after stopping, it won't start after sitting for about 15 minutes, however wait 1/2 hour or next day will start.
-
You are right ScottGem, I started needing a simple computer,however I have all these monitors laying around thought I'd use one! I have L-shaped desk and have plenty of room
-
Question I don't have the vga connection either, so I would have to buy one of those also to put on the desktop?
-
I haven't tried anything yet what do u suggest
-
I want to hook up two monitors but my EL1331G-01w emachine the vga isn't loaded on my sleek desktop
-
My fan blade is possibly bent I have a Revcor 70 19897 04 what does this equate to I could either get it from Grainger or CC son thanks for all you do!
-
Hey guys I have a rudd heat pump. Needed to change the motor . I had difficulty getting the fan blade off, so I took it to the local home improvement center to have the fan blade taken off with a...
-
Hey I have rudd heat pump and the fan motor won't turn it turns about 2 inches and stop if I need a capacitor what size my model # rjma-a048jk serial # 5592 f219812989
-
I have a Whirlpool Model # LSR6132EQ1 washing machine and the clothes mover is very loose however it still seems to wash clothes fine . What should I do next?
-
I noticed their was no hot air coming through my vents I checked the run capacitor and noticed the wires where burnt off one prong so I spliced the and reconnected. That worked fine for a week or so...
-
I want to change my run capacitor on heat pump the label fell off how do I figure out what size fits my heat pump. The current one has two[2] sets of prongs and is round is approximately 5-6" long
-
Hey guys , we rent out a house in North Carolina.The tenant abandon the property what do we do with their belongings?
-
Hey my house was built in the 1940's I have two built in fireplaces measuring about 2' wide and about 12" deep however they don't have dampers and the flames just get sucked up without providing any...
-
Wifey said it's the bottom stitch!
-
Wifey says bottom stitch is loose!
-
-
Hey I have a Euro Pro X Model # 9120 sewing machine, the stitches won't stay tight even after turning the tensioner knob on top. We also sent it out for repair and maintenance,after a few dresses...
-
Yes! It's August in North Carolina however I don't want to wait until winter to start worrying about this. What procedures do you go through if the pilot lite goes out? Could it be as simple as that?:
-
Yes this job was done by a local professional company.They first got the furnace working however the tank was underground and possible filled with water.So in turn we put a tank above ground and ran...
-
Am. Standard Oil Burner just changed oil filter,nozzle.new tank and lines. Just had the unit serviced was running for a couple of days then shut off I bypassed the thermostat and it ran for the day...
-
What should I set the multimeter for testing the transformer and should I test the contacts or the wires going out
-
How do I check my transformer of my oil furnace unit working fine then just quit.I tried direct wire eliminating the t-stat however no results please assist
-
I'm a little confused about the wiring new motor has br,br/wh,bl,wh. I understand brns go to cap. Separate posts however where on the contactor does the white and black go on .Question is it possible...
-
Yes I installed a new 5 mfd with the new motor
-
New Condenser Fan Motor runs 5 minutes then quits,however compressor continues to run ,I turned off the t-stat demand. Fan seems warm to the touch,will start up after 30 minutes or so please advice
-
My unit is a Rudd model# UPGB-025JAZ, 208/230 volts year 1997 I believe I have a single pole contactor with a 24 volt coil.. PS thanks for hanging in their with me!
-
As stated before I have fan motor br,br/w,bl,and wh wires brns are on cap. And as advised black and white to top of contactor.However L3,T3,T1, are the open posts which wire goes on these...
-
I meant to say where on the contactor does the black and white wires go I already put the browns on the capacitor thanks for all your support
-
Where on the capacitor does the white and black wires go the capacitor is loaded
-
I replaced my old fan motor with a AOS fan motor with white,black,brown,brown w/white stripes where do they go? My Previous fan motor had yellow and brown wire-nut together,purple,orange and black...
|