Search:
Type: Posts; User: topthumb
Search:
Search took 0.00 seconds.
-
Thanks for the info but I got everything back together and the engine is running like new again. I never got an answer for which one to use so since I had installed the seat with the large hole and...
-
Just tested the solenoid and it works fine. The rebuild kit only came with 1 needle valve but 2 different sized seats so it can't be the needle valve, just the seat maybe.
-
Found out that gas was getting into my crankcase and causing severe smoke and hard running. I removed the carb and replaced everything that came in the carb rebuild kit, and installed the carb back...
-
I think the problem is solved. I checked the valve clearance and they were too loose but not by much, maybe .002 or so but I guess that's enough. The engine now cranks over and even sounds a little...
-
OK, I found that video and have a question, he says to torque the rocket set screw to 45 lbs. but in my manual it says 35 lb-in.
My question is does that mean 35 inch pounds or 35 foot pounds?
-
Thanks everyone, I checked the oil and it's just under the full mark and there is no 'gas' smell to it so most likely it is the valves. I'll see if I can find that uTube video and check the valves.
-
I've owned this Troybuilt tractor with a B&S 18HP for about 8 years now and have been having problems with it now for about 4 years. What I thought was just the batteries going dead is now very...
|